User manual TASCAM DV-W14R

[. . . ] 4U Rackmount DVD/CD Duplicator User's Manual Models: TASCAM DV-W14R Safety Precautions Rackmount DVD/CD Duplicators are high-precision electronic devices. Do not use them in any manner other than as specified in this manual. Please read this manual in its entirety before you begin the installation procedure. Use of controls, adjustments, or performance of procedures other than those specified herein may result in hazardous laser exposure. [. . . ] The Load function enables you to transfer data from the source DVD Writer drive to the current partition of the hard disk drive. (Note: P:A stands for partition A. ) You can load as many disc images as the number of partitions available on the hard disk drive. 9. 2 Delete Image Use the Delete Image function to delete an image stored in a particular partition. 9. 3 Image Info Use the Image Info function to display basic information for an image file stored in a particular partition. 9. 4 Compare Image Use the Compare Image function to compare the contents of a disc in the source DVD Writer with the image file in the partition. 9. 5 Select Image The internal hard disk drive was partitioned and formatted at the factory. An alphabetical letter identifies each partition. Each partition is approximately 5GB in capacity. The number of partitions depends on the capacity of the hard disk drive. Use the Select Image function to select an image file that is stored in a specific partition on the hard disk drive. 18 Rackmount DVD/CD Duplicator User's Manual 9. 6 Image Src Drive 9. 6 Image Src Drive Use the Image Src Drive function to select the DVD Writer drive as the source from which you can load data into a particular partition as an image file. 9. 7 Image Format Info The partitions on the hard disk drive can be configured to store a CD (1GB), DVD (5GB), or a Double Layer (DL) (10GB) image. The factory partitions the hard disk drive for DVD images at (5GB per partition). Use the Image Format Info function to verify this setting. 10. Edit Track (for CD only) The Edit Track functions enable you to create and copy a collection of songs from different audio discs. Note: The CD+G value must be set to OFF before you can use the Track Extraction feature. For more information, refer to "12 Advanced Setup (Adv Setup)" on page 27. 10. 1 CD to CD Edit You can use this function to copy tracks from one or more discs and burn them to a CD-R. This function works only in the 1x4 mode of operation. The CD to CD Edit function enables you to select specific tracks from various audio discs, combine them to create a collection of songs, and copy the collection to blank CD-R/CD-RW discs. Note: CD-R discs support up to 80 minutes of audio. Therefore, the number of tracks that can be copied onto a single disc depends on the length of each individual track. Insert a source disc into the source optical drive and a blank CD-R disc into the target drive. [. . . ] Refer to "12 Advanced Setup (Adv Setup)" on page 27 for more information. Then execute function "12. 11 CD+G" on page 30 to change the setting to the ON state. Follow the instructions to exit the Advance Setup first, and then execute the [1. Copy] function. 8. How do I copy a CD Text disc?The CD Text feature is set to "OFF" as a default. [. . . ]