User manual TASCAM GB-10

[. . . ] D01128320B GB-10 Guitar & Bass Trainer/Recorder This device has a serial number located on the bottom panel. Please record it and retain it for your records. Serial number: __________________ OWNER'S MANUAL IMPORTANT SAFETY INSTRUCTIONS CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. [. . . ] Use the INPUT volume control on the right side panel to adjust the input level of the GUITAR IN jack. TASCAM GB-10 45 5-Recording Recording Before following these procedures, adjust the input level and open the Home Screen. Press the RECORD [º] button briefly to start ordinary recording. Press the [ª] button after pausing to complete the creation of an audio file with the music recorded up to the moment that recording was paused. Recording a few seconds before pushing the record button (prerecording) The unit can capture up to 2 seconds of input signal during recording standby, allowing recording to start before the RECORD [º] button is pushed. Press and hold the RECORD [º] button briefly to start recording standby. The RECORD [º] button indicator blinks, and the PRE ( ) icon appears on the display. Press the RECORD [º] button again briefly to start recording. Input signal is recorded starting up to 2 seconds before the button was pushed. The RECORD [º] button indicator lights when recording. Press the [ª] button to stop recording. To pause recording, press the RECORD [º] button. To resume recording to the same file, press the RECORD [º] button again. When recording starts, the RECORD [º] button indicator lights and the display shows the elapsed and remaining recording times. Press and hold the RECORD [º] button to enable the prerecord function and put the unit into recording standby. The RECORD [º] button indicator blinks when in recording standby. (See "Recording a few seconds before pushing the record button (pre-recording)" on page 46. ) 2. Press the [ª] button to stop recording. To pause recording, press the RECORD [º] button. To resume recording to the same file, press the RECORD [º] button again. 46 TASCAM GB-10 5-Recording Press the [ª] button after pausing to complete the creation of an audio file with the music recorded up to the moment that recording was paused. TIP Use this function in combination with the auto-recording function to record without missing the beginning of a performance. NOTE If the unit was put into recording standby less than 2 seconds before this function is used, recording will start from the time when recording standby was enabled. · You cannot pause during overdubbing. (The RECORD [º] button does not respond if pushed. ) TIP Using the overdubbing function, you can record over the same file multiple times, allowing you to use this unit as a simple multitrack recorder. When overdubbing multiple guitar solos, for example, keep the guitar input off until just before the solo to avoid recording unnecessary noise. [. . . ] No card is in the unit, so recording is not possible. There is no file that can be played back. There is no playback file, so DIVIDE and OVERDUB cannot be executed. TASCAM GB-10 91 19­Messages Message System Error 5 System Error 6 System Error 7 System Error 8 System Error 9 If any of these errors occur, turn the unit power OFF and restart it. If the power cannot be turned OFF, remove the batteries and disconnect the AC adaptor (if connected). [. . . ]