User manual TASCAM IF-DA8

[. . . ] The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED. When replacing the fuse only a correctly rated approved type should be used and be sure to re-fit the fuse cover. -- CONSULT A COMPETENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. 11) Power Sources -- This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions. 12) Grounding or Polarization -- This product may be equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. 13) Power-Cord Protection -- Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. 14) Outdoor Antenna Grounding -- If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and builtup static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. 15) Lightning -- For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. 16) Power Lines -- An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. 17) Overloading -- Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in risk of fire or electric shock. 18) Object and Liquid Entry -- Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. 19) Servicing -- Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 20) Damage Requiring Service -- Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged. b) if liquid has been spilled, or objects have fallen into the product. [. . . ] The eight sub-groups of the console are used for the surround channels and also for the DTRS recorder. The IF-DA8 provides high-quality D/A conversion to drive the surround monitor amplifiers, while passing the digital signal transparently to the recorders. Digital I/O format Sampling frequency D/A resolution Clock source LOCKED indicator TDIF-1 44. 1 kHz, 48 kHz, ±6% 24-bit D I/O2, external word clock Lights when valid clock source received at selected input 75 75 (auto terminating) 482 x 48 x 204. 5 mm (19 x 1-7/8 x 8-1/16 in. ) 2. 5 kg (5. 51 lbs. ) 120V (U. S. A. /Canada) 230V (Europe) 240V (Australia) 10 W Rack mounting kit 1. 4 Specifications WORD CLOCK IN LINE OUTPUTs (1­8) Output impedance Maximum output level (0 dBFS) Nominal output level S/N ratio (IHF-A) Crosstalk between adjacent channels (10 kHz) T. H. D. (@ 1 kHz, nominal output level) XLR-type, balanced outputs 75 +15 dBu, +20 dBu, +24 dBu +4 dBu > 100 dB > 70dB Power consumption < 0. 01% Supplied accessories WORD CLOCK THRU Dimensions (w x h x d) Weight Power supply 1. 4. 1 Dimensional diagram 6 TASCAM IF-DA8 IF-DA8 D/A Converter 1. 4. 2 Block diagram 1. 4. 3 Rack mounting TASCAM IF-DA8 7 » IF-DA8 TEAC CORPORATION Phone: (0422) 52-5082 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan 7733 Telegraph Road, Montebello, California 90640 5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada Privada De Corina, No. 18, Colonia Del Carmen Coyoacon, Mexico DF 04100 5 Marlin House, Marlins Meadow, The Croxley Centre, Watford, Herts. Bahnstrasse 12, 65205 Wiesbaden-Erbenheim, Germany 17 Rue Alexis-de-Tocqueville, CE 005 92182 Antony Cedex, France P. A. [. . . ]