User manual TASCAM IF-DM

[. . . ] Please refer to www. tascam. com to obtain this update. Do not proceed to install the IF-FW/DM until your DM-3200 is running V1. 20 or higher. DM-24 Requirements The DM-24 must be running V3. 00 software to use the IF-FW/DM. tascam. com or your local service center to obtain this update. [. . . ] More than one FireWire connector on a computer does not mean each connector has its own bus. More often, all connectors go to the same bus on the computer. If you require additional FireWire devices, it is necessary to add a FireWire card, thus adding a separate bus, for those devices. meters. · The maximum FireWire cable length is 3 Configuring the Computer Macintosh The IF-FW/DM uses the FireWire audio/ MIDI services provided by OSX, so it is not necessary to install drivers. You must have OSX 10. 3. 5 or higher installed on your Mac to use the IF-FW/DM. Previous operating systems do not include the correct built-in services. Make the connections as described above. Power up the Mac TASCAM IF-FW/DM Owner's Manual 3. Open Audio/MIDI set and verify that the IF-FW/DM device is present 5. Configure your DAW to use the IF-FW/ DM Core Audio device according to the instructions for your application. Installation O Windows It is necessary to install driver software in order for Windows to recognize the IF-FW/ DM. An installer is provided for this purpose, the drivers cannot be installed manually from Windows Device Manager. On the CD-ROM that came with your IF-FW/DM is a PC Driver installer. Launch the installer from the CD or copy it to your hard drive and launch it from there. The installer is launched by clicking "setup. exe". NOTE 4. The New Hardware dialog will appear in the lower right of the Windows desktop. When presented with any Windows Logo warnings, click Continue Anyway. Installation activity will continue in the New Hardware dialog in the lower right of the Windows desktop. Do not click on anything during this activity - allow it to finish. "Your new hardware is installed and ready to use" will appear in the lower right of the Windows desktop. Click "Next" in the Setup/Installation window. The Setup/Installation window will present a "Finished" message. Your IF-FW/DM is installed and ready to use. The IF-FW/DM should be disconnected from the PC to begin driver installation. 1. [. . . ] This may happen if the sample rate or clock source for the mixer is changed without removing the FireWire cable first. 10 TASCAM IF-FW/DM Owner's Manual Setup Enable WDM When first installed, the IF-FW/DM will 4 active stereo pairs of audio through its WDM driver. If you are using a DAW that cannot use ASIO and you want to access all 24 channels of audio, click this option. It may take 1 to 2 minutes for Windows to finish reconfiguring with a total of 12 stereo pairs of WDM audio. This affects the start-up time of the computer as well. TASCAM IF-FW/DM Owner's Manual 11 » IF-FW/DM TEAC CORPORATION TEAC AMERICA, INC. Phone: +1-323-726-0303 7733 Telegraph Road, Montebello, California 90640 www. tascam. com Phone: +81-422-52-5082 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan www. tascam. com TEAC CANADA LTD. Phone: +1905-890-8008 Facsimile: +1905-890-9888 5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada www. tascam. com TEAC MEXICO, S. A. [. . . ]