User manual TASCAM VL-M3

[. . . ] Connect the left speaker and the right speaker with the included speaker cable. D01096520A Specifications Amplifier Power: Speaker Unit: Enclosure: Frequency response: Sensitivity: Input connector: Input impedance: Power requirements: 12 W + 12 W 3" Full-Range Bass reflex type 46 Hz-20 kHz, +0/­3 dB ­6dBV (0. 5 Vrms) RCA pin kack 5 k AC adaptor (TASCAM PS-1818) AC adaptor input: AC 100-240V, 50/60 Hz AC adaptor output voltage: 18V DC AC adaptor output electric current: 1. 8 A Power consumption: 15 W Dimensions (W x H x D): 100 x 152 x 126 mm 3. 94 x 5. 98 x 4. 96 in. Weight Left channel active unit: 1. 2 kg/2. 65 lb Right channel passive unit: 1. 1 kg/2. 43 lb VL-M3 Powered Monitor OWNER'S MANUAL Installation The speaker placement is important for monitoring sounds correctly. To get the best performance of the speaker system, please follow the instruction explained below. · Place the active unit on the left side of listener. [. . . ] Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Only use attachments/accessories specified by the manufacturer. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13 Unplug this apparatus during lightning storms or when unused for long periods of time. 14 Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. · Do not expose this apparatus to drips or splashes. · Do not place any objects filled with liquids, such as vases, on the apparatus. · Do not install this apparatus in a confined space such as a book case or similar unit. · The apparatus draws nominal non-operating power from the AC outlet with its POWER or STANDBY/ON switch not in the ON position. · The apparatus should be located close enough to the AC outlet so that you can easily grasp the power cord plug at any time. · The mains plug is used as the disconnect device, the dis c onne c t devic e s ha ll re m a in re adily operable. · If the product uses batteries (including a battery pack or installed batteries), they should not be exposed to sunshine, fire or excessive heat. · CAUTION for products that use replaceable lithium batteries: there is danger of explosion if a battery is replaced with an incorrect type of battery. Replace only with the same or equivalent type. · Caution should be taken when using earphones or headphones with the product because excessive sound pressure (volume) from earphones or headphones can cause hearing loss. · If you are experiencing problems with this product, contact TEAC for a service referral. Do not use the product until it has been repaired. Included items The items included in the product are listed below. Take care when opening the package to avoid damaging the items. Keep the packaging materials for transportation in the future. [. . . ] Use audio cables that are free of damage. Do not send signals other than audio signals to the unit. The polarity of an audio cable connected to the unit should match the pin assignments. Cautions on installation Do not install in the following types of places. Doing so could degrade the sound quality and/or cause malfunctions. [. . . ]