User manual TASCO TRAIL CAMERA 119203C

[. . . ] A new photo is taken every 30 seconds for as long as motion/heat events are detected. The LCD display makes set up a breeze in the field. The Trail Cam is rugged and weatherproof. 2 QUICK GUIDE: TASCO TRAIL CAMERA 1. Open the camera by releasing the latches on the right side of the camera. [. . . ] Battery Life--Time that camera will function in the field. Dependent on temperature, number of images and number of flashes during that time. Setup--Using the display menu and buttons to set the date/time, and still photo or movies option. Trigger Speed--Time delay between a subject passing in front of PIR sensor and the image capture of that subject. All Tasco Trail Cameras have a trigger speed of less than one second. 5 Front of Camera PIR Flash Camera Lens LCD Display SD Card Slot Control Panel Inside Front Button & Display Detail PIR Detected (or Low Battery) LED Lock Tab Setup, Menu & Power Buttons Parts Guide 6 Setup and Operation Guide 1. Open the Cam by pulling out on the two latches on the right side. Install 4 "D" cell batteries (flat base of all batteries contacting springs), and insert an SD card (not included, use any capacity from 16MB to 8GB. Do not substitute MMC cards. ) in the slot to the right of the 5 buttons as indicated on the slot cover (upside down, with the notched corner of the card on the left and metal contacts of the card facing the back of the slot). Press the card down until you hear it click into place. If the Cam is turned on without a card in place, it may not turn off-reset it by pulling one of the batteries out partway, insert a new or empty SD card, and put the battery back in place. Only remove or insert cards with power off. If you are using the camera for the first time, you should set the date and time so your photos will be "stamped" correctly. Briefly press the Menu button-the first two digits of the year will flash, prompting you to enter the year (a). Use the Up/Down buttons to set the current year, then press ENTER. Set the month the same way, and press ENTER again. The display will then change to let you set the day, with only the last two digits blinking (b). Again use the Up/Down buttons to change the day if necessary and press ENTER. To set the time, use Up/Down to set the hour and minute. The time display uses the 24 hr standard, so 2:00 PM is indicated as "1400", etc. a b 3. After the date and time have been set, press ENTER. Then the camera icon will and the word "Lo" will blink (c). By pressing UP/DOWN, the camera will cycle between Lo resolution still photo, Hi resolution still photo, and movie (video) modes. [. . . ] · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules. [. . . ]