User manual TAURUS AP 2040

[. . . ] --Ensure that appliance is used in condition of a stable and horizontal surface. --Leave at least 15 cm of space on the back and sides of the appliance, and at least 30 cm of space above the product when using. --Fully extend the appliance's power cable before each use. --Do not use the appliance without its filter(s) correctly in place. [. . . ] This saves energy and prolongs the life of the appliance. --Do not use the appliance to dry textiles of any kind. iNSTALLATION --Be sure to remove all packaging material from inside the appliance. --Ensure that the appliance is level with respect to the floor. --Do not cover or obstruct any of the openings of the appliance. --The plug must be easily accessible so it can be disconnected in an emergency. --Make sure that all the product's packaging has been removed. --Remove the appliance's protective film and follow figures 1, 2, 3, 4. --To eliminate the smell given off by the appliance when used for the first time, it is recommended to have it on at full power for 2 hours in a well-ventilated room. --Prepare the appliance according to the function you wish to use: uSE: --Extend the cable completely before plugging it in. --Attach the appliance to its base / connector making sure that it is correctly fitted into place. --Attach the appliance to its base making sure that it is correctly fitted into place. --Ensure that the electronic connector is properly attached to the appliance. --Guide the appliance to direct the flow of air in the desired direction. --Turn the appliance on, by using the on/off button. uSE: --Press two times to enter the first fan speed, and the first indicator is on; --Press three times to enter the second speed, and the second indicator is on; --Press four times to enter the third speed operation, and the third indicator is turned on; --Press five times to enter the fourth speed and light the fourth indicator; --Press six times to turn off; cHILD LOCK: --Long press the "Switch button" for 3 seconds to enter the child lock mode, --the child lock indicator light will show blue. In the child lock mode, other button will be locked. --Hold the "Switch button" for 3 seconds again, the child lock indicator light would be off with this function. fILTER BUTTON: --When the filter life expires (about 2500hr), the filter replacement indicator will flash to remind you, it is high time to change the filter. --Please replace the filter consulting figures 1 , 2 , 3 , 4. --After changing the filter, hold the "Filter button" down for 5 seconds to reset sLEEP BUTTON: --In the state of power-on, press the "Sleep button" briefly, the purifier enters the sleep mode, and all the lights except the sleep status indicator are off. If any key is pressed, the display will resume for 30 seconds, and then press any key again within 30 seconds to exit sleep and enter the automatic mode. [. . . ] sUPPLIES --Supplies can be acquired from distributors and authorised establishments (such as filters, etc. NB: These specifications are subject to change without notice of purpose of improvement. Un cop transcorreguts 30 segons sense prémer el botó, la pantalla s'apagarà. --Depozitai aparatul într-un loc care s nu fie la îndemâna copiilor i/sau a persoanelor cu capaciti fizice, senzoriale sau mentale reduse, ori care nu au experiena sau cunotinele necesare. [. . . ]