Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual TEAC 3FD0010A. We hope that this TEAC 3FD0010A user guide will be useful to you.
Lastmanuals help download the user guide TEAC 3FD0010A.
Detailed instructions for use are in the User's Guide.
[. . . ] PLEASE READ THE ENTIRE INSTALLATION GUIDE THOROUGHLY BEFORE YOU BEGIN THE INSTALLATION. Use a standard floppy controller card or the floppy connector (34 Pin) on the motherboard.
Preparing your Personal computer for FD-235 Floppy Drive Installation
CAUTION: TURN OFF YOUR COMPUTER AND UNPLUG IT FROM THE AC POWER SOURCE BEFORE INSTALLING THE FD-235. FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.
1. [. . . ] FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.
1. Unplug your computer from the power source. Refer to your computer system manual for this procedure. If you are replacing a current floppy, note the cables that are connected to your floppy disk drive, as these same cables will be required to install your FD-235. The floppy interface cable is the flat "ribbon" type, and the power connector consists of the 4 or 2 separate wires attached to a single connector. Your system may also have a single ground wire attached to the floppy disk drive. Carefully disconnect all cables from your floppy disk drive. Drive is not properly set in CMOS setup. Or controller card is not configured correctly. Check setup by referring to controller documentation. Controller is not receiving disk change signal. Or disk drive is malfunctioning.
Indicator light comes on as soon as power is applied and stays on. Drive type mismatch during boot
Invalid media or Track 00 bad when formatting.
The same directory is displayed for different diskettes.
Drive not ready error reading drive X. No diskette inserted in the drive or motor not spinning. [. . . ] Drive type mismatch during boot
Invalid media or Track 00 bad when formatting.
The same directory is displayed for different diskettes.
Drive not ready error reading drive X. No diskette inserted in the drive or motor not spinning. General failure error reading drive X Diskette not formatted. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE TEAC 3FD0010A
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual TEAC 3FD0010A will begin.
