User manual TEAC AG-H300MKIII

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Read this manual carefully to get the best performance from this unit. install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] < Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control. < If the remote control unit is operated near other appliances which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the other appliances may operate incorrectly. Insert two "AAA" (R03 or UM-4) dry batteries. Make sure that the batteries are inserted with their positive "+" and negative "_" poles positioned correctly. Battery Replacement If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones. Precautions concerning batteries < Be sure to insert the batteries with correct positive "+" and negative "_" polarities. Never use different types of batteries together. < When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones. < Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. Remplacement des piles Si vous remarquez que la distance entre le boîtier de télécommande et le lecteur devient plus courte pour un fonctionnement correct, ceci indique que les piles sont usées. Press this switch to turn the unit standby or off. The equipment draws nominal non-operating power from the AC outlet with its POWER switch in the OFF position. When the POWER switch of the main unit is depressed, use this button to turn the unit standby. When the POWER switch of the main unit is depressed, use this button to turn the unit on or standby. The standby indicator lights when the unit is in the standby mode. When the unit is turned on, it goes off. When the POWER switch of the main unit is depressed, use this button to turn the unit on. When operating the remote control unit, point it towards the remote sensor. For private listening, insert the headphones plug into this jack, and adjust the volume by turning the VOLUME knob. [. . . ] Make sure there is power to the AC outlet by plugging another item such as a lamp or fan. E The unit is too close to a TV set or similar appliances. Relocate the units so they no longer interfere with each other, or turn them off. e Connect the turntable's ground cord to the SIGNAL GND terminal. [. . . ]