User manual TEAC AI501DA

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] 3 Insert the wire into the hole in the terminal screw and turn the terminal cap right (clockwise) to connect it securely. V Caution This unit works with speakers that have nominal oo impedances between 4 Ω and 8 Ω. Use of speakers with impedances of less than 4 Ω, in particular, could cause the protection circuit to activate and sound output to stop. In some cases, damage could even occur to this unit and the speakers. This unit's red terminal is positive (+) and its black teroo minal is negative (_). If oo the exposed end of a core wire in a speaker cable contacts another cable or terminal, a short could occur. ooNever allow a speaker cable to short. To oo avoid noise, do not bundle the speaker cables with the power cord or other cables. Loosen the terminal cap before using the banana plug. After completing all other connections, insert the power plug into a power outlet. Unplug the cord from the outlet when not using the unit for a long time. Use of a differU ent cord could cause fire or electric shock. C USB input port (USB) Use this to input digital audio from a computer. Connect it to the computer's USB port, using a commercially available USB (TYPE B) cable. CAUTION Install the dedicated driver on the computer before connecting. If you connect this unit to a computer that does not have the driver installed, the operation of the computer could be impaired, including, for example, causing it to operate more slowly (see p. V Do not turn the power on until after making all connections. Carefully read the manuals of the devices that oo you are connecting and follow their instructions when making connections. Do oo not bundle connecting cables with power cords. Oo 9 Using the remote control Precautions for use V  isuse of batteries could cause them to M rupture or leak leading to fire, injury or the staining of items nearby. Please carefully read and observe the precautions on page 3. Point the remote control unit at the main unit’s remote oo sensor from within 5 meters (16 feet) of it. [. . . ] Automatic power saving caused the unit to enter standby. E  Shift the POWER switch to OFF once and then turn the power back ON. E  the batteries are exhausted, replace both of If them with new ones. E  The remote control will not work if there is an obstruction between it and the main unit. [. . . ]