User manual TEAC AR630 MKII

[. . . ] CQX1A1569Z Z Integrated Stereo Amplifier OWNER’S MANUAL MANUEL DU PROPRIÉTAIRE MANUAL DEL USUARIO A-R630 ENGLISH FRANÇAIS BEDIENUNGSANLEITUNG MANUALE DI ISTRUZIONI HANDLEIDING ESPAÑOL DEUTSCH ITALIANO NEDERLANDS < Do not expose this apparatus to drips or splashes. < Do not place any objects filled with liquids, such as vases, on the apparatus. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. [. . . ] 5 Identifying the Parts A B C D E D F G O N M L K J I H a b D G F 6 A Remote Sensor When operating the remote control unit, point it towards the REMOTE SENSOR. POWER Press this switch to turn the unit standby or off. STANDBY/ON When the power switch of the main unit is depressed, use this button to turn the unit on or standby. The standby indicator lights when the unit is in the standby mode. When the unit is turned on, it goes off. INPUT SELECTOR Use this knob (or buttons of the remote control unit) to select a source. One of the indicaotrs lights to show the selected source. TAPE 2 MONITOR When a cassette tape deck is connected to the TAPE 2 jacks, use this button to turn on or off the tape monitor function. The indicator lights when the tape monitor function is on. MUTING Use this button to mute the sound. This indicator blinks during the muting. VOLUME Turn this knob (or press the VOLUME buttons of the remote control unit) to adjust the volume. MIC Jack and MIC LEVEL knob With the microphone plugged into this jack, the sound picked up from the microphone will be heard together with the source sound selected by the INPUT SELECTOR. Turn the MIC LEVEL knob to adjust the input level of the microphone. LOUDNESS Use this button to compensate for the loss of bass at low volumes. BALANCE Use this knob to adjust the balance of the speakers. Normally, set the knob to the center position. SOURCE DIRECT Press this button to turn on or off the source direct function. When the source direct function is set to on, the button lights and you can listen to the sound without tone effects. TREBLE Use this knob to adjust the level of high frequency information. N SPEAKERS buttons Use these buttons to turn on or off the speakers. on : Sound is output from the speakers. [. . . ] E Speaker impedance is less than prescribed for this unit. E Turn the power off and reduce the volume. E Press the POWER switch of the main unit to turn it on. E If the batteries are dead, change the batteries. [. . . ]