User manual TEAC CD540E

[. . . ] · Save these Instructions for later use. · Follow all Warnings and Instructions marked on the audio equipment. 1) Read Instructions -- All the safety and operating instructions should be read before the product is operated. 2) Retain Instructions -- The safety and operating instructions should be retained for future reference. [. . . ] 2 Secure the brackets on the wall using the supplied screws. 1 < As a convenience, a set of tapered plastic anchors is supplied. If you chose to use these anchors, drill a pilot hole using a 6mm drill bit then tap the anchor into the pilot hole. Only use these anchors if they are appropriate for the materials onto which the unit is to be mounted. Consult your local hardware store if you are uncertain. Note: Before going on, make connections between the main unit and the speakers by referring to page 9. 3 Hang the main unit and/or the speakers to the mounting 2 3 tabs. Put in the lithium battery (CR2032, 3V). Close the cover. 3 3 2 2 Battery Replacement If the distance required between the remote control unit and main unit decreases, the battery is exhausted. In this case, replace the battery with a new one. Precautions concerning batteries Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. 10 Getting started The CD-X10i comes mounted with an adapter for iPod with color display (40GB, 60GB), "60GB (color) + Photo 40GB/60GB". To play your iPod through the CD-X10i, you have first to check if the factory mounted adapter fits your model of iPod. If it does not, you have to replace it with a correct one, as explained below. Press the SLEEP button repeatedly until desired time appears on the display. SLEEP 90, 60 or 30: The power will be switched off 90, 60 or 30 minutes later. CAUTION Always lower the volume level prior to plugging in your headphones. TO AVOID DAMAGING YOUR HEARING - Do not place your headphones on your head until after you have plugged them in. < If you want to check the remaining time, press the SLEEP button once. The remaining time will be displayed for a few seconds. Muting To mute the sound temporarily, press the MUTING button. Press the MUTING button again to restore the sound. Tone Control 1. To adjust the level of low frequency sound range, press the bass button. To adjust the level of high frequency sound range, press the treble button. < The MUTING indicator lights and the volume level blinks on the display to indicate that the muting is engaged. < If you change the volume or source during the muting, the muting will be canceled. Within 5 seconds, press the VOLUME buttons to change the setting. The level can be adjusted from ­5 to +5. 13 Listening to iPod Insert the iPod into the Dock of the CD-X10i. Then press the Play/Pause button (y/J) on the iPod. The CD-X10i will automatically turn on and start playback from the iPod's music list. [. . . ] Then the unit will stabilize at the temperature of its surroundings. iPod Player Cannot insert the iPod. e Remove dust or obstacles from the Dock connector of the CD-X10i and the iPod, and insert the iPod again. e Remove the iPod from the dock, wait a few seconds, and insert it again. e Software update may solve the problem. [. . . ]