User manual TEAC DV-W50D

[. . . ] ® DV-W50DK DVD±R/DVD±RW Drive User's manual To ensure the smooth handling of your warranty please write the serial number of your drive into the box. In the case of warranty you are expected to send it together with a copy of your invoice to your nearest TEAC sales representative. · Changes in specifications and features may be made without notice or obligation. · · Copyright © 2003, TEAC Deutschland GmbH. First edition: June 2003 Company and product names provided herein are trademarks of their respective companies. CONTENTS TO THE USER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 SAFETY CONSIDERATIONS RELATING TO THE FCC RULE PART 15 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] ­ Do not repair the drive or replace a part of the drive under circumstances other than designated assurance conditions. Cleaning and maintenance of your TEAC drive TEAC drive will not need maintenance if used as specified in this manual. Usually there are only problems with dirty or defective DVDs/CDs. Important: Do not use cleaning CDs which will remove dirt of the lense of the laser aided by a little brush. Do not clean the inner parts of your TEAC drive with compressed air. Any of these methods may cause damage to your TEAC drive. 3. Precautions for Installation and Operation 33 ENGLISH in poor recording. The following problems also can result occasionally: ­ The disk (DVD-R, DVD-RW, DVD+R, DVD+RW respectively CDR, CD-RW) becomes defective because of faulty recording, and cannot be read. ­ Additional recording cannot be made because of faulty previous recording. 4. CONTROLS AND FUNCTIONS ENGLISH 4. 1 Front Panel Disk tray Eject emergency hole Ventilation hole Eject button ON/BUSY indicator (LED) Disk tray Insert the disk (DVD, CD) with its label facing up. Note: Please ensure the DVD/CD is inserted in a way where the plugs at the rear of the disk tray and the spring loaded plug on the front prevent the disk from falling out of the tray. This is of major importance if the drive is used in one of the vertical positions. When using an 8cm-CD disk in horizontal position, place it on the specified position at the center of the tray. Never use it in the vertical position. 34 4. Controls and Functions ON/BUSY indicator ENGLISH The indicator LED lights in Seek, Play, Read, and Write operation. In the following table you will find a list including a description of the different drive states and their associated indicator states. Operation mode During reading/data transfer During writing Audio Play Seek Boot up (Power on PC) Tray open/close Indicator LED lit LED lit LED lit Lit when SEEK command is issued LED lit LED lit Eject emergency hole When the power is switched OFF and the eject button does NOT function, insert a metal rod (diameter of 1. 2mm or less) into this hole at a right angle to the front panel, then push the rod to eject the disk. Do this only when the device is switched off and the ON/ BUSY indicator is NOT lit. Wait more than one minute until the disk rotation is stopped when access the eject hole. Eject button Press this button to open or close the disk tray. Ventilation hole Cooling air intake port. Do not block the hole by other objects. 4 Controls and Functions 35 4. 2 Rear panel ENGLISH Ventilation outlet Analog audio output connector Interface Connector Strap switch Analog Audio output connector Power connector For stereo audio signal output. When driving external speakers, connect this connector to the audio input connector on the Sound Card or Interface Card. Note: Mating connectors: Molex 70553 or equivalent. Connector No. 1 2 3 4 Audio signal Left channel Signal Ground Ground Right channel Signal Interface connector Connect to the IDE interface card using the 40-pin flat cable. [. . . ] For details, refer to the warranty card provided with the unit. 8. 2 Technical Service Depots (Europe) TEAC Deutschland GmbH, DSPD (Germany) Technical Support Tel: 0180 5 999 588 (EUR 0. 12/min (Germany)) Mo-Fr Sa from 8:30 ­ 20:00 CET from 10:00 ­ 16:00 CET +49 (0) 611 7158 666 http://www. teac. de/RMA http://www. teac. de/support Technical Support Fax: Online RMA: Internet: 7. Technical support 43 ENGLISH TEAC UK LIMITED, DSPD (U. K. ) Technical Support Freecall: 0800 08 53 704 (U. K. only) ENGLISH Mo-Fr Sa from 8:30 ­ 20:00 CET from 10:00 ­ 16:00 CET +49 (0) 611 7158 666 http://www. teac. de/RMA http://www. teac. de/support Technical Support Fax: Online RMA: Internet: TEAC FRANCE S. A. (France) Technical Support Tel: +33 (0) 1 55 59 01 55 Mo-Fr from 9:00 ­ 16:00 CET +33 (0) 1 55 59 01 56 http://www. teac. de/RMA http://www. teac. de/support Support@teac. fr Technical Support Fax: Online RMA: Internet: Contact us by email: TEAC Service Centre Poland Galaktyczna 23 80-299 Gdansk Technical Support Tel: Mo-Fr +48 (0) 58 34 02 300 from 9:00 ­ 16:00 CET http://www. teac. de/RMA http://www. teac. de/support support_pl@teac. de Online RMA: Internet: Contact us by email: All other countries please call: +49 611 7158 600 44 8. [. . . ]