User manual TEAC DW-548D

[. . . ] ® DW-548DK DVD-ROM/CD-R/CD-RW Drive User's manual To ensure the smooth handling of your warranty please write the serial number of your drive into the box. In the case of warranty you are expected to send it together with a copy of your invoice to your nearest TEAC sales representative. · Changes in specifications and features may be made without notice or obligation. · · Copyright © 2003, TEAC Deutschland GmbH. First edition: June 2003 Company and product names provided herein are trademarks of their respective companies. CONTENTS TO THE USER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 SAFETY CONSIDERATIONS RELATING TO THE FCC RULE PART 15 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] ­ Do not repair the drive or replace a part of the drive under circumstances other than designated assurance conditions. Cleaning and maintenance of your TEAC drive TEAC drive will not need maintenance if used as specified in this manual. Usually there are only problems with dirty or defective DVDs/CDs. Important: Do not use cleaning CDs which will remove dirt of the lense of the laser aided by a little brush. Do not clean the inner parts of your TEAC drive with compressed air. Any of these methods may cause damage to your TEAC drive. 3. Precautions for Installation and Operation 33 ENGLISH in poor recording. The following problems also can result occasionally: ­ The disk (CD-R, CD-RW) becomes defective because of faulty recording, and cannot be read. ­ Additional recording cannot be made because of faulty previous recording. 4. CONTROLS AND FUNCTIONS ENGLISH 4. 1 Front Panel Eject emergency hole Disk tray Headphone jack ON/BUSY indicator (LED) Eject button Volume control Disk tray Insert the disk (DVD, CD) with its label facing up. Note: Please ensure the DVD/CD is inserted in a way where the plugs at the rear of the disk tray and the spring loaded plug on the front prevent the disk from falling out of the tray. This is of major importance if the drive is used in one of the vertical positions. When using an 8cm-CD disk in horizontal position, place it on the specified position at the center of the tray. Never use it in the vertical position. Headphone jack (ø 3. 5mm) Audio output jack for stereo headphone. The audio output of rear panel is active even when a jack is inserted into the headphone plug. 34 4. Controls and Functions ON/BUSY indicator ENGLISH The indicator LED lights in Seek, Play, Read, and Write operation. In the following table you will find a list including a description of the different drive states and their associated indicator states. Operation mode During reading/data transfer During writing Audio Play Seek Boot up (Power on PC) Tray open/close Indicator LED lit LED lit LED lit Lit when SEEK command is issued LED lit LED lit Volume control Adjusts headphone's volume. position is set at the time of shipping from the plant. Eject emergency hole When the power is switched OFF and the eject button does NOT function, insert a metal rod (diameter of 1. 2mm or less) into this hole at a right angle to the front panel, then push the rod to eject the disk. Do this only when the device is switched off and the ON/ BUSY indicator is NOT lit. Wait more than one minute until the disk rotation is stopped when access the eject hole. Eject button Press this button to open or close the disk tray. 4 Controls and Functions 35 4. 2 Rear panel ENGLISH Digital audio output connector Strap switch Power connector Interface Connector Analog audio output onnector Analog Audio output connector For stereo audio signal output. When driving external speakers, connect this connector to the audio input connector on the Sound Card or Interface Card. Note: Mating connectors: Molex 70553 or equivalent. Connector No. [. . . ] Installing Drivers and the Writer Software 7. 3 Compatibility or Interoperability to Other IDE Devices If there are any problems if other drives are connected to the same IDE port (especially IDE-Changer, Phase Change Drive, IOMEGA, and others), the DW-548D has to be connected as master or as a single drive. 8. TECHNICAL SUPPORT In case the DW-548D does not operate normally in the environment specified in this manual, contact the representative from whom you purchased the drive or our nearest sales office to you. 8. 1 Product Warranty Two years following the purchase of this unit is the guarantee period. Any failures arising from the design or production of this unit are to be repaired free of charge within two years following purchase. For details, refer to the warranty card provided with the unit. 8. 2 Technical Service Depots (Europe) TEAC Deutschland GmbH, DSPD (Germany) Technical Support Tel: 0180 5 999 588 (EUR 0. 12/min (Germany)) Mo-Fr Sa from 8:30 ­ 20:00 CET from 10:00 ­ 16:00 CET +49 (0) 611 7158 666 http://www. teac. de/RMA http://www. teac. de/support Technical Support Fax: Online RMA: Internet: 7. [. . . ]