User manual TEAC GF-650

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] The sound from speakers will be cut off while the headphones are plugged in. During recording, use this button to divide tracks. Use this button to enter record pause mode. Use this button to select the mode of track number assignment. In CD mode, use this button to clear programmed tracks. In CD mode, use this button to select a repeat mode of CD. In CD or PHONO/AUX mode, use this button to open and close the disc tray. Note: To simplify explanations, instructions refer to names of buttons and controls on the front panel, making no mention of the use of remote control unit. Hold down these buttons to search for a part of a track. Caution: < Before use, completely loosen the shipping screws by turning them clockwise with a coin and remove the stylus guard. < When turning on the power to the unit, the tone arm may move if the cum was subjected to shock during transportation and has been displaced. When you use the GF-650 for the first time, turn on the power to the unit leaving the vinyl tie intact to prevent the tone arm from moving and leave the unit alone for more than 30 seconds. 1 Press the PHONO/AUX button once or twice to select 1 Press the POWER switch to turn the unit on. When playing a 45 RPM record, use the included adaptor. Move the tone arm gently to the edge of the record (or the starting point of a track), and gently lower the tone arm. When the record finishes playing, the tone arm will automatically return to the tone arm holder and the turntable will stop. < Playing records with the dust cover down will prevent dust from settling on the turntable. Please do not place anything on top of the turntable cover, especially while playing a record. < Don't rock the unit nor switch off the power during playback. < The tone arm automatically returns to the tone arm holder when it reaches the end of recording. But with records on which the recorded groove runs into a further inner area than in the case of normal records, the tone arm may lift and return to the tone arm holder without playing towards the end of recording. < To play a 25 cm (10 inch) record, manually start playing. [. . . ] When the unit (or a record/disc) is moved from a cold to a warm place, or used after a sudden temperature change, there is the danger of condensation; vapor in the air could condense on the internal mechanism, making correct operation erratic or impossible. To prevent this, or if this occurs, leave the unit for one or two hours with the power turned on. The unit will stabilize at the temperature of its surroundings. If the surface of the unit gets dirty, wipe with a soft cloth or use a diluted mild liquid soap. [. . . ]