User manual TEAC GF-680

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] < If the remote control unit is operated near other products which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the other products may operate incorrectly. While in FM mode, tune in an FM station and extend the lead to find the best position for reception. This antenna may need to be repositioned if you move your unit to a new location. Make sure to connect the white plug to the white jacks (Left) and the red plug to the red jacks (Right). Plug this AC power cord into an AC wall socket. 2 Insert two "AAA" (R03, UM-4) dry batteries. Batteries are inserted with their positive "+" and negative "_" poles positioned correctly. Battery Replacement If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. Lower the cover slowly until the latch engages. If the latch does not engage, repeat these steps again. Lift the cover all the way up until it stops. The latch should disengage and you may now slowly lower the cover. Make sure you grasp the cover by the edges to avoid pinching yourfingers as it closes. Before use, completely loosen the screw by turning it clockwise with a coin or screwdriver. When you transport the unit, turn the screw counterclockwise to fix the turntable. 1 Press the POWER switch to turn the unit on. Each time the EEPS button is pressed, the mode is changed as follows: The standby indicator goes off. < When the unit is turned on, the MUTING indicator lights momentarily. < When using the remote control unit, press the FUNCTION button repeatedly until the desired source appears on the display. < To listen to an external source connected to AUX jacks , press the AUX/PHONO button. < If you play an external source and a record simultaneously, the sound will be mixed. [. . . ] E Press the POWER switch to turn the unit on. e If the batteries are dead , change the batteries. E Use remote control unit within the range (5m /15ft) and point at the front panel. E Clear obstacles between the remote control unit and the main unit. [. . . ]