User manual TEAC LP-R400

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Reception will now be forced to monaural, reducing unwanted noise. Hold down the TUNING button ( or ) until the frequency display begins to change. AM broadcast Turn around the AM antenna and/or the unit to find the best position for AM stations. FM broadcast Extend and turn around the FM antenna so that you can receive the stations clearly. When the or button is pressed momentarily, the frequency changes by a fixed step. Press the or button repeatedly until the station you want to listen to is found. To store more stations, repeat steps 1 to 4 . You can store FM and AM stations into preset channels 1 to 9 respectively. < You can tune in another station even after the ENTER/MEMORY button has been pressed. < Before use, completely loosen the transportation screw by turning them clockwise with a coin and remove the stylus guard. When playing a 45 RPM record, use the included adaptor. 1 Press the PHONO/AUX button once or twice to select 5 Gently push the clamper to the right to release the tone Be careful not to pinch your finger. When the playback has been finished, the tone arm automatically returns to the tone arm holder and the rotation stops. To stop playback manually, slightly lift the tone arm using the cue lever and return it to the tone arm holder. 8 Gently lower the tone arm by slowly releasing the cue You can lower the tone arm manually if the cue lever has not been raised. < Playing records with the dust cover down will prevent dust from settling on the turntable. Please do not place anything on top of the turntable cover, especially while playing a record. ENGLISH < It takes a few seconds for the unit to load the disc. Wait until the total number of the tracks and the total play time of the disc are displayed. CD: A commercial pre-recorded CD CD-R: A finalized CD-R CD-RW: A finalized CD-RW NO TOC CD-R: A CD-R which has yet to be finalized NO TOC CD-RW: A CD-RW which has yet to be finalized blank: No disc or unreadable disc < The disc must be placed in the center of the disc tray. If the disc is not correctly loaded, it may not be possible to open the tray again once it has closed, so you should ensure the disc is always centered on the tray. < Do not force the tray by hand during opening and closing operations. [. . . ] To prevent this, or if this occurs, leave the unit for one or two hours with the power turned on. The unit will stabilize at the temperature of its surroundings. If the surface of the unit gets dirty, wipe with a soft cloth or use a diluted mild liquid soap. Be sure to remove any excess liquid completely. [. . . ]