User manual TEAC PCD0010A

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Make sure you grasp the cover by the edges to avoid pinching your fingers as it closes. Hook your fingers into the round holes of the turntable platter and gently lift. Be sure to connect the power cord to an AC outlet which supplies the correct voltage. Hold the power plug when plugging or unplugging the power cord. Before use, completely loosen the screws by turning them clockwise with a coin or screwdriver. Press this button to turn the unit on or off. In record pause mode, use this knob to adjust the recording level. When operating the remote control unit, point it towards the REMOTE SENSOR. When the unit is on, this display will light. For private listening, first reduce the volume level to minimum. Then insert the plug from your headphones into the PHONES jack, and adjust the volume by turning the VOLUME knob. If the tone arm does not automatically return to the tone arm rest, pull the STOP lever. AM broadcast Turn around the unit to find the best position for AM stations. FM broadcast Extend and turn around the FM antenna so that you can receive the stations clearly. < Never place more than one disc on the tray. < The disc must be placed in the center of the disc tray. If the disc is not correctly loaded, it may not be possible to open the tray again once it has closed, so you should ensure the disc is always centered on the tray. < Do not force the tray by hand during opening and closing operations. < It takes a few seconds for the unit to load the disc. Wait until the total number of the tracks and the total play time of the disc are displayed. Total number of the tracks total play time of the disc CD: A commercial pre-recorded CD CD-R: A finalized CD-R CD-RW: A finalized CD-RW NO TOC CD-R: A CD-R which has yet to be finalized NO TOC CD-RW: A CD-RW which has yet to be finalized blank: No disc or unreadable disc Disc playback starts from the first track, and the PLAY indicator (y) lights on the display. < If you load the disc, and then press the PLAY button without having first closed the disc tray, the disc tray closes and playback starts. [. . . ] If normal operation cannot be obtained, unplug the power cord from the outlet and plug it again. E If the disc is dirty, clean the surface of the disc. It may not be possible to play back CD-R/CD-RW discs. E If the disc is dirty, clean the surface of the disc. [. . . ]