User manual TEAC QUICK CD-W552PUK

[. . . ] Very important: TEAC assumes no responsibility for data loss caused by the operation that is not in accordance to this document, or data loss caused by natural disaster, fire, power outage, or spontaneous defect of this product. However, it is required that the device driver be installed from the CD provided with this product when you use Windows 98 Second Edition (Windows 98SE). Set the provided CD in one CDROM drive (not in the USB drive) of your computer. [. . . ] (6) After sucessfully finishing the installation the hardware assistant is closed with Finish. Important: If an error message appears you may move one step backwards or cancel the process (using Cancel) and try it again later. If installation of the driver fails you will see in the device manager an exclamation mark (!) or a question mark (?). Remove the driver and start the installation process again. (6) There appear some messages on the screen followed by the appearance of an CD-ROM icon in the window My Computer. Very important: When you are using Windows 98SE and the drive is connected for the first time, it is required to read and install the device driver file from the provided CD. Disconnecting the drive The drive can be disconnected from the PC if it is not used any longer during the actual session. It is of major importance to logoff the drive at the PC before disconnecting it. (1) Close the program that uses the drive. (2) Confirm that the busy indicator of the drive is off. (3) Click the Remove icon on the Taskbar. Driver installation under Windows98SE (1) Connect as described before the dedicated AC adapter to the drive, then connect the USB interface cable between the drive and your computer. (2) Add New Hardware Wizard starts automatically. (3) Ensure your driver CD is inserted correctly into a CD-ROM drive and select "Search for the best driver for your device (Recommended)". (4) When specifying the location to search the driver, select "CD-ROM drive" or check "Specify a location" and input the location of the driver folder if you have saved them in advance on your computer (The window below is an example if the folder CDW552PU in drive C: is specified). Click Next. (4) Select the removing drive with the name assigned to the drive. (5) The Remove Hardware confirmation message , , Save to remove storage device" appears. (6) Remove the plug of the USB cable from the USB terminal of the computer. page 2 Important: Do not disconnect the power cord or the USB cable which connects the PC and the drive without carrying out the logoff procedure. Otherwise this may lead to loss of data and erroneous operation of the PC. Important: If liquid is allowed to poor into the drive, it may cause a serious malfunction, an electric shock or a fire. When cleaning with liquid, be sure to remove the provided AC adapter from the wall outlet after disconnecting the drive from your computer. Important: Do not use cleaning CDs which will remove dirt of the lense of the laser aided by a little brush. [. . . ] Refer to the operation manual of your computer or software for details. Cleaning and maintenance of your TEAC USB CD-RW drive TEAC drives will not need maintenance if used as specified in this manual. Usually there are only problems with dirty or defective CDs. page 3 Specifications Applicable disc format CD-DA, CD-ROM Mode-1, CD-ROM XA Photo CD multi-session, CD-TEXT CD-I, Video CD, CD Extra (CD Plus) CD-ROM, CD-DA CD-R, CD-RW 12 cm, 8 cm Applicable disc type Type Size An actual list of media recommended by TEAC can be found at TEACs web site under www. teac. de/support. Please select the menu "CD-Medias". [. . . ]