User manual TEAC T-R670

[. . . ] Read this manual carefully to get the best performance from this unit. TO THE USER This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential area. This device generates and uses radio frequency energy and if not installed and used in accordance with the instructions, it may cause interference to radio or TV reception. [. . . ] Using a flat-bladed screwdriver, set to the appropriate 230V or 120V position according to your area. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture. < Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object should get into the set, contact your dealer. < When removing the power plug from the wall outlet, always pull directly on the plug, never yank the cord. < Do not attempt to clean the unit with chemical solvents as this might damage the finish. < Keep this manual in a safe place for future reference. In the following cases, function buttons may not work properly. In these cases, unplug the AC power cord and plug it again. Extend this into a "T" shape and connect the two wires at the base of the "T" to the provided matching transformer, as shown. After completing connection, plug the transformer into the "FM 75" socket. Extend the top of the "T" and fix with thumb tacks, or the like, to a wall or window frame for the best possible reception. In an area where FM signals are weak, it will be necessary to use an outdoor antenna with 3 or more elements. If you are using a 300-ohm antenna, connect it to the tuner via the supplied matching transformer. A high-performance AM loop antenna provided with the tuner is sufficient for good reception in most areas. Snap the supplied loop antenna into the hinge on the rear of the unit, and connect the wires running out the loop antenna to the AM terminals, as shown. When you actually try listening AM programs later, you may want to turn the loop antenna on the hinge for the best possible reception. If the AM loop antenna provided does not deliver sufficient reception (because you are too far from the transmitter or in a concrete building, etc. ), it may be necessary to use an outdoor AM antenna. Use an insulated wire more than 15 ft (5 m) long, strip one end, and connect this to the terminal as shown. The antenna wire should be strung outdoors or indoors near a window. for better reception , connect the GND terminal to a reliable ground. [. . . ] A The power can be switched off at the desired time. The sleep time can be changed by 10 minutes' step. press the SLEEP button repeatedly until the desired time appears. SLEEP 90 : The power will be switched off 90 minutes later. [. . . ]