User manual TEAC TD0015A

[. . . ] 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or groundingtype plug. [. . . ] PLAY (y) Use this button to start playback, recording, finalizing and erasing. PAUSE (J) Use this button to pause playback or recording. K OPEN/CLOSE In CD mode, use this button to change the display. Y SHUFFLE In CD mode, use this button for shuffle playback. In CD or PHONO/AUX mode, use this button to open and close the disc tray. < This button don't work in FM/AM mode. L VOLUME Note: To simplify explanations, instructions refer to names of buttons and controls on the front panel, making no mention of the use of remote control unit. Turn this knob to adjust the volume. M Disc Tray N MUSIC SKIP (. //) In CD mode, use these buttons to skip tracks. Hold down these buttons to search for a part of a track. 13 Basic Operation 2 Listening to the Radio 1 1 3 2 1 Press the POWER switch to turn the unit on. 1 Select FM or AM using the FM/AM button. 2 Select a source by pressing the corresponding button. 2 Turn the TUNING knob to tune in a station. < To listen to an external source connected to AUX jacks, select AUX by pressing the PHONO/AUX button once or twice. When PHONO/TAPE is selected, set the Input Selecting switch by the turntable to "RECORD" or "TAPE. " < The TUNED indicator lights when a station is correctly tuned in. < The STEREO indicator lights when an FM stereo broadcast is tuned in. 3 Play the source, and adjust the volume by turning the VOLUME knob. If the reception is poor AM broadcast Turn around the unit to find the best position for AM stations. FM broadcast Extend and turn around the FM antenna so that you can receive the stations clearly. 14 Listening to a Record 1 1 2 adaptor 4 transportation screw 7 3 6 5 < Before use, completely loosen the transportation screw by turning them clockwise with a coin and remove the stylus guard. 4 Put the record on the turntable. When playing a 45 RPM large hole single record, use the included adaptor. 1 Press the PHONO/TAPE/AUX button once or twice to select 5 Select the speed. PHONO/TAPE. 2 Gently open the dust cover. Be careful not to pinch your finger. 6 Gently push the clamper to the right to release the tone arm. clamper 7 Raise the cue lever to lift the tone arm off the tone arm support. 3 Set the Input Selecting switch to RECORD. tone arm cue lever 15 Listening to a Record 2 When the playback has been finished, the tone arm automatically returns to the tone arm holder and the rotation stops. 9 To stop playback manually, slightly lift the tone arm using the cue lever and return it to the tone arm holder. 8 tone arm 8 Move the tone arm gently to the edge of the record (or the starting point of a track). cue lever 9 Gently lower the tone arm by slowly releasing the cue lever. You can lower the tone arm manually if the cue lever has not been raised. cue lever < Playing records with the dust cover down will prevent dust from settling on the turntable. < Do not place anything on top of the turntable cover, especially while playing a record. 16 Listening to a CD 1 1 5 3 24 1 Press the CD button. 4 Press the OPEN/CLOSE button (L) to close the tray. "--" blinks for a few seconds. When no disc is set, "nOdISC" appears on the display. < It takes a few seconds for the unit to load the disc. The track being played will be played repeatedly. If you press the MUSIC SKIP button and select another track, the track you selected will be played repeatedly. It is also possible to select a track to be repeated in the stop mode. Press the REPEAT button twice and then select the track number by pressing the MUSIC SKIP button. Press the PLAY button to start playback. < If one of the following buttons is pressed, shuffle mode will be cancelled: SHUFFLE in the stop mode, OPEN/CLOSE, POWER, FM/AM, PHONO/AUX < Shuffle playback works with finalized discs only. < If one of the following buttons is pressed, repeat mode will be cancelled: OPEN/CLOSE, POWER, FM/AM, PHONO/AUX < Repeat playback works with finalized discs only. 19 Programmed Playback Up to 32 tracks can be programmed in the desired order. < Insert a disc and select "CD" before beginning programming. < Shuffle playback does not work during programmed playback. < Programmed playback works with finalized discs only. 1 Press the PROGRAM button in the stop mode. 4 When the selection of track numbers has been finished, press the PLAY button (y) to start program playback. To check the programmed order In the stop mode, press the MUSIC SKIP button repeatedly to show the track numbers that have been stored in memory. "PROGRAM" indicator blinks, and "P-01" appears on the display. 2 Press the MUSIC SKIP button (. or /) to select a track. To add a track to the end of the program In the stop mode, press the PROGRAM button. [. . . ] Er ** Erase the last track of the CD-RW disc. Er ALL Erase all the tracks of the CD-RW disc. -**db Increment level NODISC No readable disc has been loaded. P-** Program number UN FIN Unfinalize the CD-RW disc. Specifications Amplifier Section Output power . [. . . ]