User manual TEAC W-600R

[. . . ] 1) Read Instructions -- All the safety and operating instructions should be read before the product is operated. 2) Retain Instructions -- The safety and operating instructions should be retained for future reference. 3) Heed Warnings -- All warnings on the product and in the operating instructions should be adhered to. 4) Follow Instructions -- All operating and use instructions should be followed. [. . . ] Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. E ) if the product has been dropped or damaged in any way. F ) when the product exhibits a distinct change in performance _ this indicates a need for service. 21) Replacement Parts -- When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. 22) Safety Check -- Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 23) Wall or Ceiling Mounting -- The product should be mounted to a wall or ceiling only as recommended by the manufacturer. 24) Heat -- The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. Do not plug the power cord of any component into AC outlets and do not turn their POWER switches on until all connections have been performed. < Make sure to connect : white plug w white jack(L:left) red plug w red jack(R:right) < Be sure to insert each plug securely. To prevent hum and noise, do not bundle the connection cords with the power cord or speaker cord. (General export models only) Be sure to remove the power cord from the AC outlet before repositioning the voltage converter switch. Using a flat-bladed screwdriver, set to the appropriate 230V or 120V position according to your area. The heads and tape path should be cleaned and demagnetized periodically. Cleaning Tape Path < Apply head cleaning fluid to a cotton swab or soft cloth, and lightly rub the heads, capstan and all metal parts in the tape path. < Also clean the pinch roller using rubber cleaning fluid. Demagnetizing Heads Be sure that the power is off, then demagnetize the heads using a demagnetizer. For details of its use, read its instructions. Caution: If the surface of the unit gets dirty, wipe with a soft cloth or use diluted neutral cleaning liquid. Do not use thinner, benzine or alcohol as they may damage the surface of the unit. Use your finger or a pencil to turn the cassette's hub and take up any slack tape. Do not store tapes in the following places: < On top of heaters, exposed to direct sunlight or in any other places with high temperatures. [. . . ] In case of trouble with the unit, please take the trouble to look through this chart and see if you can solve the problem yourself before you call your dealer or TEAC service center. No power e Check the connection to the AC power supply. E Select the correct DOLBY NR type according to how the tape was recorded. E If the safety tabs of the cassette tape have been broken off, cover the holes with adhesive tape. [. . . ]