User manual TECHNICS SA-GX100

[. . . ] Electrical safety can only be guaranteed if the product is connected to a suitable earth connection. It is dangerous to modify or attempt to modify the appliance. In the event of a malfunction, do not attempt to repair the appliance yourself, but contact a qualified technician. After using the cooktop, ensure the indicator on the knob is turned to the "off" position and close the mains gas delivery tap or the gas cylinder tap. [. . . ] If after this period the burner still has not lit, or if it has gone out for accidental reasons, wait at least 1 minute before repeating the operation. O Burner selection The symbol printed above each knob on the control panel (drawing in fig. 4) indicates the correspondence between knob and burner. The selection of the most suitable burner depends on the diameter and capacity of the cookware (see table). It is important that the pot diameter is suited to the power of the burner, in order to not compromise its high efficiency. Pot / Pan diameter RTE 753 SF Burner Left Auxiliary Right Auxiliary Right Semirapid Left Semirapid Triple Crown Minimum diameter 60 mm (with reducer) 60 mm (with reducer) 100 mm 100 mm 200 mm Maximum diameter 140 mm 140 mm 160 mm 180 mm 260 mm Burner Auxiliary Semirapid front Semirapid rear Rapid Triple-crown RTF 765 SF Minimum diameter 60 mm (with reducer) 160 mm 160 mm 200 mm 240 mm Maximum diameter 140 mm 200 mm 200 mm 240 mm 260 mm Adapting to different types of gas If it is necessary to adapt the cooktop to gas different than that for which it is designed, the injectors will have to be replaced. The spare injectors, if not provided with the cooktop, are available at the Service Centres. The injectors to be replaced should be selected according to the injectors table. The injectors are identified by their diameter, expressed in hundredths of mm and printed on the body of the injectors themselves. Replacement of the injectors Remove the grates and the flame spreader from the cooktop. Use an open-end spanner to replace the injectors J (fig. Pay particular attention that the electrical cable and gas supply pipe are positioned so as to not come in contact with the hot parts of the oven casing. Furthermore, if an oven without a cooling fan is installed under the cooktop, it is necessary to make openings in the built-in unit to ensure proper air circulation. These openings must guarantee a free surface of at least 300 cm2 distributed as shown in figure 8. Installation in the top (surface of the furniture) The cooktop can be installed on all furniture, as long as it is heat resistant (withstanding temperatures up to at least 90°C). The dimensions of the hole to make on the furniture surface and the minimum distances from the back and side walls and above the appliance are indicated in figures 5 and 6. Consider that: When the cooktop is installed without an oven beneath, it is mandatory to use a dividing panel between the bottom of the cooktop and the furniture underneath, at a minimum distance of 10 mm. If the cooktop is matched with an oven, place a partition at a minimum distance of 15 mm, while maintaining ventilation as specified in fig. In any case the electrical connection of the two appliances must be realized separately, both for electrical reasons as well as to facilitate their extraction. It is recommended that you use an oven with a forced cooling fan. 16 Fixing the cooktop The cooktop must be fixed to the furniture as follows: Position the appropriate sealing gasket provided with the cooktop along the external perimeter of the hole made in the furniture according to the diagram in fig. 5, so that the ends of the strips are perfectly joined to one another without overlapping. [. . . ] Perform the connection without producing any type of stress on the appliance. 17 ATTENTION: should it be necessary to replace the supply cord, connect the wire in accordance with the following colours/codes: BLUE BROWN YELLOW-GREEN NEUTRAL (N) LIVE (L) EARTH CLEANING To keep your cooktop in good condition, it should be cleaned regularly after each use once it has cooled. Attention: Never remove the knobs from their seats. never use steam or high-pressure cleaners. [. . . ]