User manual TECHNISAT DIGIT S3 HD

[. . . ] Brief Instructions TECHNISTAR K4 ISIO Digital cable receiver with Internet access to receive DVB-C and IPTV channels 1 Illustration LED display Up/down arrow keys TV/Radio On/standby CI module slot Card reader: >  Insert the CONAX Smartcard into the card reader (gold chip facing down and at the front as you insert) and push it in as far as it will go. Inserting the CI / CI+ module: > Consult the CI/CI+ module and card manufacturer’s instructions. > Insert the Smartcard you want into the relevant CI module. > Now insert the CI module carefully into the slot. [. . . ] > Every additional press of the Option button moves the highlight down one line at a time. Some options are selected directly in this window. Other options for a number of subordinate selection options are located in the options groups. Highlighting one of these option groups automatically opens another window on the left. > > > You can use the up/down arrow keys within the options group to highlight one of the options listed there. By pressing the up/down arrow keys, it is possible to move the highlight from line to line and to move upwards and downwards page by page using the page up/down buttons. The highlighted option is selected by pressing the OK button and you exit the option selection area. If you do not want to select an option or wish to leave the Options selection area without making any changes, simply press the Option button until it is hidden. 1 Switching on > Switch the digital receiver on by pressing the On/Standby button either on the device or on the remote control. If the user-dependent parental control (TechniFamily) is activated, the user selection now appears. 2 Switching off > > Press the On/Standby button either on the device or on the remote control to switch the device off again. The receiver is now in standby mode, and the time is displayed on the receiver panel (where activated). If the time is not shown, the receiver still needs to acquire it. To do this, switch the receiver on, and set it to reception of a major channel (e. 30 seconds to automatically acquire the time. 1 Using the up/down channel keys > Use the up/down arrow keys on the receiver to select a channel, or use the Channel +/- buttons on the remote control to scroll up or down one channel at a time. 2 Using the numeric keypad > Use the numeric keypad keys to enter the number of the channel you want. For for for for channel channel channel channel slot slot slot slot 1 14 234 1567 For example: 1 1, then 4 2, then 3, then 4 1, then 5, then 6 then 7 When entering channel numbers with multiple digits, you have approx. Three seconds after pressing a key to complete the entry. If you wish to enter a number consisting of only one, two or three digits, you can speed up the entry procedure by keeping the key OK pressed a little longer on the last digit. 3 Using the Navigator (channel list) > Press the OK key. > You can view additional data about the current program by pressing the INFO button. [. . . ] When you get to the place you want in the recording, you can return to normal playback mode by pressing the Pause / Play button. 4 Jog shuttle function To quickly and accurately navigate to a position in the recording, your receiver also has a 'jog shuttle' function. This is used as follows: > > > > During playback press the Jogshuttle button (freeze frame) to access jog shuttle mode. By pressing the right/left arrow keys (repeatedly if necessary), you can change the speed and direction of the playback. [. . . ]