User manual TECHWOOD DVR100

[. . . ] DVR100 READ THIS FIRST This audio system is made and tested to meet exacting safety standards. W AR N I N G : To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture. C A UT ION R IS K OF E LE C T R IC S HOC K . DO NOT OP E N. be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. [. . . ] If the subwoofer has been turned on, to change the subwoofer's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). Press SPEAKER LEVEL again to exit. Setting the Speaker Size 1. This function allows you to configure the receiver for your Front, Center, Rear Surround and for a Subwoofer (SW). Press SPEAKER CONFIG again and F -S MA L L appears. To change to F -LARGE, press N ote: I f floor standing speakers are used, choose F-LARGE. If bookshelf or small satellite speakers are used, choose F-SMALL. When using small speakers a powered subwoofer must be added to play low frequencies. Press SPEAKER CONFIG again and SW-YES appears. If you are not using a subwoofer, press or to change to SW-NO. Press SPEAKER CONFIG again to finish SPEAKER SIZE settings. N ote: If front speaker is set at F-SMALL, subwoofer cannot be set to SW-NO. Setting the Speaker Distance When you have arranged your home theater (speakers, receiver, and any components), you can change the speaker distance entered in the receiver's memory. Imagine a straight line from the front left speaker to the front right speaker. Measure the distance in a perpendicular line from your listening position (for example, your couch) to the imaginary line. N ote: Do not meaure the distance to the speakers, just the line. Repeat Steps 1­2 for the rear (surround) speakers. Measure the distance in a perpendicular line from your listening position (for example, your couch) to the center speaker. Press SPEAKER DELAY on the remote SP DIST appears. Press SPEAKER DELAY again and F 20FT (front) appears. To change the distance between the listening position and the front speakers, repeatedly press or until you reach the desired level ( 0 to 30 FT ). To change the distance between the listening position and the center speaker, repeatedly press or until you reach the desired level ( 0 to 30 FT ). Press SPEAKER DELAY again and S 20dB (surround)appears. To change the distance between the listening position and the surround speakers, repeatedly press or until you reach the desired level ( 0 to 30 FT ). [. . . ] Source being played is not recorded or broadcast in surround sound or stereo. One or more rear speaker wires is not making good contact, No sound from the center speaker. Surround Mode is not set toDTS, DOLBY DIGITAL, DOLBY PRO LOGIC, DOLBY PRO LOGIC II If the receiver does not operate normally due to external effects such as static electricity, disconnect the power plug from the outlet and insert again to return to normal operating conditions. 23 CARE Keep the receiver dry; if it gets wet, wipe it dry immediately. Use and store the receiver only in normal temperature environments. [. . . ]