User manual TECSUN PL-600

[. . . ] PL·600 FM STEREO/LW/MW/SW· SSB PLL SYNTHESIZED DUAL CONVERSION REGEIVER OWNER'S MANUAL PLEASE READ THIS MANUAL BEFORE OPERATION TABLE OF CONTENTS MAJOR FEATURES OF THE PL-600 2 3 DIAGRAMS GETTING STARTED WHAT THE PL-600 INCLUDES INSTALLING BATTERIES PREVENTING BATTERY ACID LEAKAGE USING THE INCLUDED AC ADAPTOR/CHARGER CHARGING BATTERIES IN THE PL-600 4 BASIC RADIO OPERATION SETTING THE CLOCK SETTING THE TIMERS STORING A RADIO STATION INTO TIMER MEMORY ACTIVATING/DEACTIVATING 6 WORKING WITH MEMORY STORING STATIONS INTO MEMORY SELECTING/CHANGING MEMORY PAGES ACCESSING WHAT IS STORED INTO MEMORY DIRECT MEMORY ACCESS MANUAL MEMORY SEARCH MEMORY AUTO-SCAN DELETING A MEMORY'S CONTENTS DELETING ALL MEMORY PAGE CONTENTS MOVING A STORED FREQUENCY CUSTOMIZING 7 MEMORY PAGES . . SYSTEM SET CODES SYSTEM SET CODE TABLE CHANGING SYSTEM SET CODES DEFAULT FACTORY SYSTEM SET CODES MONITORING THE CURRENT STATUS OF SET CODES AND OTHER SETTINGS 8 9 10 ADDITIONAL PL-600 CONTROLS LISTENING TO SHORTWAVE STATIONS TROUBLESHOOTING 15 15 16 18 . . THE TIMER USING THE SNOOZE FEATURE , 2 3 5 5 5 5 5 5 7 10 10 10 11 11 11 12 12 12 12 12 12 13 . . . . . . . 13 13 14 14 15 15 5 CLOCK AND TIMER FEATURES o OWNER'S MANUAL 1 MAJOR FEATURES OF THE PL-600 · FM Frequency Range: 87-108 MHz or 76-108 MHz (For Japan) · Shortwave Frequency Range: 1711- 29999 KHz · 9/1 OKHz tuning step selector for Medium Wave (MW) reception · 1 kHz tuning step for the display of Medium wave and Shortwave · AM (LW/MW/SW) dual conversion. [. . . ] Use the numeric keypad to key-in the time in 24 hour format. Within 5 seconds of finishing, press/release the 'TIME' (2) button or wait until the clock digits stop flashing. The clock digits appear in the center of the display (34). Press/release the button labeled 'Time' (2). The clock HOUR digits flash in the display. 1 , CLOCK AND TIMER FEATURES When the timer activates, it turns on the radio, with the timer activation symbol and the playtime appear flashing in the display. The radio will play the station stored into timer memory and shut off automatically when the playtime counts down to 00 or until you turn the radio off with the POWER/SLEEP button. The 'snooze' feature can also be used (see section titled USING THE SNOOZE FEATURE). There are three methods to set the timer. You can set Timer A or B separately. continued ACTIVATING/DEACTIVATING TIMER THE For a timer to turn on the radio, it must be activated. A timer can be activated/deactivated with the radio on or off. To activate the timer, press/release the TIMER A or TIMER B button. The timer symbol will appear in the display. To deactivate a timer, press/release the TIMER A or TIMER B button. The timer symbol will disappear from the display. USING THE SNOOZE FEATURE When the timer activates and turns the radio on, the timer activation symbol (36) appears flashing in the display. While it is flashing, press/release the SNOOZE/LIGHT button (7). The radio will turn off and then turn on again in 10 minutes. This process can be repeated 3 times. STORING A RADIO STATION INTO TIMER MEMORY To hear a radio station when the timer activates, the station must be stored into timer memory. Turn on the PL-600 and tune to the desired station. Press the TIMER A or TIMER B button for more than 1 second, then release. The timer symbol flashes in the display twice. NOTE: To monitor the frequencies stored into timer memory A and B, perform a three second press of the SYSTEM SET button while the radio is turned off. The set code information and the frequencies stored into timer memory flash in the display. 6 WORKING WITH MEMORY . vv I At the factory, the PL-600 is set up with 10 pages of memory (from 01-10), each page holding 50 frequencies plus 100 frequency memory in PO. This enables storing of 600 frequencies into memory. [. . . ] Perform a reset if the solutions outlined below don't resolve the issue. To perform a reset, press the reset button with a paper clip or similar object. Assure that the LOCK feature is not engaged. Assure that the radio has power (batteries installed or AC adaptor plugged in). [. . . ]