User manual TEFAL 5S ICE CRUSHER

[. . . ] However, most fruits, vegetables, nuts, aromatic herbs and other food can be chopped with the Tefal® INGENIO® 5 SECONDS. Safety information This appliance must be used only on the TEFAL® INGENIO® 5 SECONDS Chopper 900ml. This appliance should never be used by children or by people with a disability which would prevent them from using it safely. [. . . ] Use & Care INGENIO® 5 seconds chopper* (*: for a first chopping result) Congratulations on your purchase of the Tefal® INGENIO® 5 seconds chopper. This manual chopper includes (**): fig A - 1 anti-slip container with a 900ml capacity - 1 lid with pull mechanism and a locking system - 1 patented cutting rotor composed of two independent stainless steel blades - fig. W ; for chopping all your fruits, vegetables, nuts and herbs (apples, strawberries, tomatoes, nuts, herbs, …). - 1 patented cutting and mashing rotor composed of independant stainless steel blades - fig X ; for mashing all your cooked vegetables or fruits (potatoes, carrots, courgette, Using 1. Remove all the parts from the box and clean them thoroughly by hand before using for the first time. Place the container on a stable and dry working surface. Remove the cutting rotor from its protective case. Put the lifting aid on the table, it must be stable (otherwise just turn it). Hold the wing with one hand and with the other hand hold the cutting rotor on the fixed wing and the blades in the same position as the fixed wing (light green), then push the cutting rotor from the top on the lifiting aid. It will lift up the herbs, garlic, chili from the bottom of the container and chop it very finely. Remove lifting aid when using other ingredients. Place the cutting rotor in the container with the blades above one another to optimize the space for the ingredients you want to chop. Cut the big ingredients such as carrots or onions in a piece shorter than the length of the blades so that they will not block the blades of the cutting rotor. Then place them in the container while making sure that the cutting rotor will remain straight. Place the lid on the container making sure that the hexagon on the cutting rotor fits into the recess in the lid. Place one hand on top of the lid to hold the appliance down on the working surface. Then use the other hand to grip the pull mechanism on the lid. The first pulling motion needs to be done with strength and speed. [. . . ] It is recommended to handwash the cutting rotors for a longer life of your product. Be extremely careful when doing so as the blades are very sharp. Safe storage of the cutting rotors First, place the lower cutting blade of the rotor in its protective case. [. . . ]