User manual TEFAL EASYSTORE TURBO

[. . . ] English 031837 - 50/04 PRO EXPRESS & PRO EXPRESS TURBO 2- LOCKING SYSTEM FOR RETAINING THE IRON ON THE BASE Your steam generator is fitted with a system for retaining the iron on its base. · Locking hoop for retaining iron for ease of carriage. · Hoop release button to free the iron for use. 3- PREPARING YOUR STEAM GENERATOR CLICK (1) (2) (3) 1- UNDERSTANDING YOUR STEAM GENERATOR Steam control button Temperature control slide for the iron Thermostat light Turbo steam button (depending on the model) Iron retaining hoop Retaining hoop release button Iron rest Removable water tank filler cover CLICK (4) (5) Retaining hoop release button 1. To carry your steam generator by the iron handle: - place the iron on the iron rest of the generator and raise the retaining hoop over the iron until it locks into place (audible click) (1). - grasp the handle of the iron to carry your steam generator (2). [. . . ] · Do not use descaling agents for rinsing out the boiler, as they could damage it. 12- PUTTING YOUR STEAM GENERATOR AWAY 1. 2. Turn off at the main O/I switch and unplug. Raise the retaining hoop over the iron until it locks into place (audible click) (21). Your iron is then safely retained on its base. Warning: do not touch the soleplate while still hot. On the model with an automatic reel, press the reel button and guide the cord with your free hand. Allow the iron (and iron rest) to cool for 30 minutes. 6. You can then put your steam generator away carrying it by the iron handle (23). II. TO RINSE THE BOILER WITHOUT THE RINSING ACCESSORY Before attempting to rinse the boiler of your generator, it is essential to leave it to cool for at least 2 hours in order to avoid any risk of scalding. If the orange "boiler rinse" light flashes, you can continue ironing normally but remember to rinse the boiler first, the next time that you use it. Check that the generator is cold and unplugged. Place your steam generator on the edge of your sink, with the iron to one side, standing on its heel. Unscrew the cord clip by turning a quarter turn to the left. Using a coin, gently unscrew the boiler rinse plug. Holding your steam generator in a tilted position, and using a jug, fill the boiler (in the base unit) with 1/4 litre of tap water. Shake the base unit for a few moments and then empty it completely over your sink. To obtain the best result, we recommend that this operation is done twice. Screw back and tighten up the boiler rinse plug with a coin. The next time you use the generator, hold down 1. TO RINSE THE BOILER USING THE RINSING ACCESSORY For greater effectiveness and for ease of operation, you are advised to use the rinsing accessory provided in the box. It will make it easier to rinse the boiler as the generator will need less handling. CLICK (a) 1 (21) (22) (23) 2 the "restart" button for 2 to 3 seconds to turn off the orange light. Your rinsing accessory has been designed to work on a wide range of taps. It is supplied with 2 types of membrane (a) (b). If you do not wish to, or cannot use the rinsing accessory, refer to the advice in paragraph II (next page). [. . . ] · Rinse out the boiler after every 10 uses, when the orange indicator light flashes (see chapter 11). If your water is hard, increase the frequency. · Hold the "Restart" button down for 2 to 3 seconds fo turn off the indicator light. · You have already rinsed the boiler and the orange "boiler rinse" light is flashing. · Brown streaks come through the holes in the soleplate and stain the linen. · You have not pressed for long enough on the "restart" button. · You are using chemical descaling agents or additives in the water for ironing. [. . . ]