User manual TEFAL PEPITO

[. . . ] Check that the voltage of your appliance is the same as your mains. Before each use, unwind the flex completely. If you want to use your appliance with the grill plate (depending on model), place the drip tray in the appliance. If you use your appliance in casserole function, do not place the drip tray in the appliance. [. . . ] If you use your appliance in casserole function, do not place the drip tray in the appliance. Place the cooking dish or the grill plate (depending on model) on the base of the appliance and make sure it is stable and well positioned. In case an extension cable is necessary, it must be earthed, and its cross section must be at least 1 mm2. When using an extension cable, secure it safely so that people do not trip over it. Set the thermostat to the position of your choice (the positions indicated in recipes can be adjusted depenENG ding on your own taste). Note : If you use your appliance in grill function, pre-heat it for 8 to 10 minutes at thermostat 4. For other functions, pre-heating is not necessary. Warning : never put the lid on when pre-heating the appliance empty. The pilot light (depending to model) switchs off when the temperature is reached. : on first use, it is normal for the heating element to give off a small amount of smoke and odour. TEFAL SA has an ongoing policy of research and development and may modify these products without prior notice. ASSEMBLING THE APPLIANCE Depending on the accessories supplied with your appliance, you can try 3 kinds of cooking : casserole grilling steam cooking (1) NOT TO BE DONE ! Warning : never use the glass lid as a dish on the base of the appliance. (depending on model) (depending on model) (1) For steam cooking : a. Scouring powders and scouring pads are not recommended. Note : if food has burned, leave the cooking dish to soak a little while before cleaning. · NEVER IMMERSE THE APPLIANCE WITH HEATING ELEMENT AND CORD IN WATER. STORING THE APPLIANCE So that the appliance does not take too much place in your cupboard, we advise you to stock the different accessories as indicated on the following drawing : (some accessories are supplied depending on model) FOR U. K. USERS ONLY : ADDITIONAL INFORMATION AND INSTRUCTIONS WIRING INSTRUCTIONS WARNING : ALL APPLIANCES MUST BE EARTHED. IMPORTANT : the wires in this lead are coloured in accordance with the following codes. Green and Yellow : Earth N: Blue E: Green and Blue : Neutral or black yellow or green Brown : Live L: Brown or red Connect the Green/Yellow wire to the terminal in the plug marked "E" (or by the Fit correct fuse(13 amp) earth symbol) or coloured Green and Use cable Yellow. gripper Connect the Brown wire to the terminal in the plug marked "L" or coloured Red. ENG Connect the Blue wire to the terminal in the plug marked "N" or coloured Black. Seek professional advice if you are unsure of the correct procedure for the above. ABOUT YOUR FACTORY FITTED PLUG The cord is already fitted with a plug incorporating an appropriate fuse. [. . . ] Seek professional advice if you are unsure of the correct procedure for the above. ABOUT YOUR FACTORY FITTED PLUG The cord is already fitted with a plug incorporating an appropriate fuse. If the plug does not fit your socket outlet, see paragraph below. Should you need to replace the fuse in the plug supplied, an appropriately rated approved BS 1362 fuse must be used (refer to electrical specification for fuse rating). [. . . ]