User manual TEFAL QUICK HOT

[. . . ] 2 Position the cartridge in the tank A and screw the cartridge J a quarter turn into the bottom of the tank. Certain models also have an indicator light K, which indicates when it is necessary to change the cartridge. For these models, when this light K flashes during use, it is time to change the cartridge fig 5. 3 To change the cartridge, remove the used cartridge and replace it with a new Claris Aqua Filter system cartridge, sold as an accessory (ref XH 5000) fig 6. [. . . ] As soon as you release the button, the hot water stops running. Follow the same procedure with the the ambient water button G to obtain 200 ml of water at room temperature fig 9 or fig 10. If you would like to get ambient water after hot water has been running, fill half a mug and throw it away or wait 5 minutes as a minimum. If you would like to get hot water after ambient water has been running, fill half a mug and throw it away. 6 With certain models, you have the possibility of presetting the amount of water automatically delivered by the appliance yourself. To programme the amount for the hot water button H, press both hot water H and ambient water G buttons simultaneously fig 7. The indicator light K flashes to indicate that you are now in programming mode. Then press the hot water button H until you obtain the desired amount of water in your container fig 3. Finally confirm the recorded amount by simultaneously pressing buttons G and H fig 7. The light will turn off at the end of the programming mode. To programme the amount for the ambient water button G, follow the same procedure as for programming the hot water button H, pressing the ambient water button G to obtain the desired amount of water fig 10. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. Do not use the appliance. No attempt must be made to disassemble the appliance or safety devices. The type and series number are shown on the base of your model. 7 Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 8 Important: safety instructions Note: This appliance does not produce boiling water. Therefore please check any food or beverage instructions before using this appliance for such things as baby food and drinks. The hot water from this appliance cannot be used for sterilising purposes. Therefore, please check the instructions before using this appliance when preparing such things as drinks and food for babies. · Carefully read the operating instructions before first use of the appliance and keep them in a safe place: Tefal shall not be held responsible for incorrect use. · Only connect the appliance to an earthed socket. Check that the power supply voltage shown on the appliance's rating plate corresponds to that of your installation. · Take care not to place the appliance on a hot surface like a hot-plate or use it close to a naked flame. · Immediately take the plug out from the mains if the appliance does not function correctly. [. . . ] · All appliances are subject to severe quality inspection. Practical tests using appliances taken at random are conducted and this may explain any marks showing prior use. · You are advised not to use multiple sockets and/or extension cables. Safety limits This hot water dispenser must only be used with water in the tank. Tefal accepts no responsibility for any damage resulting from the appliance being used for unauthorised purposes, faulty connections, dangerous handling, operations and repairs. [. . . ]