User manual TEKA CB 380

[. . . ] · If the extractor fan is going to be used simultaneously with equipment powered by a non-electric energy source, e. g. : gas cookers, then the room must have sufficient ventilation. · Excessive fat accumulation in the kitchen hood and metal filters is a fire risk and may also cause dripping, therefore the inside of the kitchen hood and the metal filters must be cleaned at least once a month. · The lower part of the kitchen hood must be fitted at least 50 cm. FOLLOW THE HOBS´ MANUFACTURER'S MINIMUM RECOMMENDATIONS. · Never leave gas hobs lit if not covered by a container. [. . . ] Vertically adjustable tubecovers. Switch on the extractor fan a few minutes before you start to cook in order to ensure that a steady air flow has been established before fumes appear. Allow the extractor fan to run for several minutes after you have finished cooking (between 3 to 5 minutes) in order to expel all the grease from the outlet duct. This prevents the return of grease, smoke and smells. Programming timer Proceed as follows: 1) Turn the kitchen hood on and choose the required speed. Suction indicators 1, 2 and 3 will start to flash. 3) Select the required time by pressing the increase and decrease speed selectors. There is a variation of 10 in 10 minutes. 4) Once the required time has been selected, press "timer" again to memorise the program. The speed indicator in use will start to flash. 5) The kitchen hood will turn itself off once the programed time has finished. The intensive speed "H" can only be selected manually and will change to speed 2 after approximately 10 minutes. B C D, E Filter saturation indicators Clean the filters when the saturation indicator lights up. 10) Mount the tubecovers, attaching the lower one to the support (H) as per the detail in figure 2 Wall support. Lift the upper tubecover up to the desired 6 Wall plugs (Ø8 x 40). 11) Fit the clips (F) to the support (C). 12) Centre the support (C) around the shape marked; trace and drill the fixing points for the 2 Ø6, 4 x Ø18, washers. Attach the support (C) 2 Ø6, 4 x Ø12, washers. with the long bolts (D) (Ø4 x 30). 13) Fit the part (B) if the inner tube (not 4 Screws M4 x 12. 14) Attach the inner tube with a clamp (not 2 Clips. supplied) to (B) or on to the motor's air outlet vent as the case may be. Installation 15) Once the inner tube is fitted, fit the lower Fig. 1 (Page 31) tubecover around the extractor fan outlet and On installing the kitchen hood make sure attach the upper tubecover with the screws (G) that the Safety Instructions set out on page (Ø3, 9 x 13). [. . . ] 7) Drill into the wall and fit the wall plugs (R) 3) Mount the EASYCLEAN panel again (K). 8) Hang the kitchen hood; tighten the screws 4) Remove the tubecovers (E). Fit the diffuser (M) (M4 x 12) with the washers (A3) (Ø6, 4 x (C) on to the motor's air outlet vent. Fit the Ø12) and the long bolts (S) (Ø5 x 45) with the tubecovers back on (E). [. . . ]