User manual TELEFUNKEN DPF 10933

[. . . ] For details about po wer connection, see paqe xx. Note to users in the United States of America Warning: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] When you change the paper feeder to the specified one, the paper type and roll width are set to the stored values. 1 Press the Paper Select key until your desired paper feeder indicator blinks. The roll paper width is displayed in the paper cut length indicator.  You can press the Clear Modes key to cancel the indication. 2 Press the Paper Select key to select the paper feeder. 3 Press the Paper Size key to select the roll paper width.  When you select "Manual Feed" for the paper feeder, you cannot specify the paper size. 4 To use the New-ABCDE-size paper, select "New size" using the + and - keys.  When the paper feeder indicator blinks for "New size", the 24, 18, 12, and 9 indicators are lit. 22 COPYING PAPER TYPE/ROLL WIDTH ENTRY FUNCTION 5 Press the Fusing Temperature key to select the paper type.  If you do not want to store the settings, press the Clear Modes key. S You cannot use the repeated copying function during manual copying in the default setting. To change the setting, contact your service representative. S You can set either paper or an original first. When you have set both of them, the copier starts copying automatically. S When you press the Clear/Stop key after setting an original, the original is delivered without copying. S When you remove paper from the manual feed table, pull it out gently by holding its left and right sides. 1 Press the Paper Select key to turn on the indicator. "Manual Feed" 2 Pull down the manual feed table. COPYING 27 COPYING WITH MANUAL FEED 3 Set the copy paper guide to match the paper width and direction (the copy paper guide is an option). 4 Insert the paper lightly along the copy paper guide (the copy paper guide is an option).  Do not release the paper until it is fed into the copier. [. . . ] S To avoid a possible build-up of ozone, make sure to locate this copier in a large well ventilated room that has air turnover of more than 30m3/hr/person. S Install the copier in a location free from dust. If dust gets into the copier, a fault might occur. MAINTAINING YOUR COPIER 55 WHERE TO PUT YOUR COPIER S When you install the copier near another electronic equipment, they might affect each other. [. . . ]