User manual TELTONIKA AT1000 QUICK START GUIDE V1.1

[. . . ] If wrong battery is used, the device may malfunction. Teltonika takes no responsibility for device damage caused by third party batteries. Any installation and/or handling during a lightning storm is prohibited. Please use cables provided with AT1000 device. [. . . ] Found New Hardware window 5 Extract and launch VCPDriver_V1. 1_Setup. exe. This driver is used to detect AT1000 device connected to the computer. Click 'Next' in driver installation window. Figure 3. Driver installation window Installation wizard will prompt you with several windows telling that software did not pass Windows Logo test. Click 'Continue Anyway' button to continue. Figure 4. Windows Logo pass window 6 Setup will continue installing drivers and will display a window about successful process in the end. Click 'Finish' to complete setup. Figure 5. Successful installation window Note: if drivers did not install successfully or device is not recognized, please make sure that device is connected to PC and reinstall the drivers. 5 Batteries Figure 6. Inserting the batteries. 7 AT1000 is autonomous device which uses two R14 (IEC 60086 standard) batteries. Batteries used in this device are single charge Li based type and should have the following parameters: · Voltage: 3. 6V · Nominal capacity: 5500mAh · Max pulse current not less than: 2000mA Teltonika recommended batteries are available for sale from Teltonika office or distributors. Only with these batteries correct device operation and (or) prevention of permanent damage to device is guaranteed. Warning: use only the same sort of batteries in pair and do not mix old batteries with new ones. Note: if inserting the batteries for the first time, make sure insulating tape is removed!In order not to discharge batteries, please remove them if not using the device. After inserting new batteries to the device, please remember to reset the battery level counter in the configurator. If new batteries are not inserted, do not try to reset this counter (more details about the battery level counter are described in user manual documentation). 6 Configurator AT1000 Configurator is software used to setup the device. You can save or read the settings and read modem IMEI number with it. Please download latest version of AT1000 Configurator from Teltonika webpage: http://avl1. teltonika. lt/downloads/AT1000/. To use Configurator with AT1000, make sure that batteries are inserted in the device and it is connected to PC. In the configurator please choose correct COM port used by device. To find out which COM port is used follow these steps: · Right-click on 'My Computer' and choose 'Properties'; · Go to 'Hardware' and click on 'Device Manager'; · Expand 'Ports (COM & LPT)' menu. See COM port number near 'STM Virtual COM Port'. 8 Figure 7. [. . . ] COM port: click this drop-down list to choose which COM port is used by AT1000 to connect to PC. See chapter 6 to find out number of the port. Refresh button: click it to refresh all available ports on PC. This button is used when you connect AT1000 to PC while Configurator software is already launched, but it did not detect Virtual COM Port yet. 8 UPDATING FIRMWARE TO THE LATEST VERSION Teltonika is constantly working on improvement of the devices, and strongly recommends using the latest versions of the firmware. [. . . ]