User manual TERRAILLON TFA LINER

[. . . ] Graphing product applications (Apps) are licensed. See the terms of the license agreement for each product. In this guidebook, references to TI-83 Plus also apply to the TI-83 Plus Silver Edition. References to TI-84 Plus also apply to the TI-84 Plus Silver Edition. EasyData, EasyTemp, Go!Motion and LabPro are trademarks of Vernier Software and Technology. [. . . ] The experiment length is calculated from the settings that you typed. Select OK to return to the main screen. EasyData Page 13 Collecting data manually (Events with Entry) In Events with Entry mode, each sampled value becomes a y value; you enter the x value. To collect data in Events with Entry mode 1. Select Setup from the EasyData main screen, and then select Events with Entry. The main screen is displayed with current settings. EasyData waits for you to collect the first sample. 3. Set up (or wait for) the condition that you want to capture. When ready to capture the current sampled (y) value, select Keep. You are prompted to assign an x value to define the data point. EasyData Page 14 5. EasyData waits for you to collect the next point. 6. When you have finished collecting data, select Stop. The data points are displayed as a graph (a calculator scatter plot). When the sample is finished, examine how well your “walk” matched the graph. Do one of the following: – – – Select Retry to redisplay the same graph to match. Select New to display a new graph to match. Select Main to return to the main screen. EasyData Page 18 Changing a sensor’s measuring unit You can change the measuring unit for a connected sensor. With a motion detector, for example, you can change the unit from meters (m) to feet (ft). To change the measuring unit 1. From the EasyData main screen, select Setup, and then select the menu item for the sensor, such as Dist for the motion detector. A menu is displayed showing the possible units for the connected sensor. 3. Select the unit that you want EasyData to use. The Sensor Setup screen shows the selected unit. Select OK. EasyData Page 19 Setting a zero reference (zeroing the sensor) By default, EasyData uses the data sampled by the connected sensor. If the motion detector senses a distance of 2. 3 meters, for example, EasyData displays 2. 3 meters. [. . . ] You agree that you do not intend to nor will you, directly or indirectly, export, re-export or transmit the Program or technical data to any country to which such export, re-export or transmission is restricted by any applicable United States regulation or statute, without the proper written consent or license, if required of the Bureau of Export Administration of the United States Department of Commerce, or such other governmental entity as may have jurisdiction over such export, re-export or transmission. Government pursuant to a solicitation issued on or after December 1, 1995, the Program is provided with the commercial license rights and restrictions described elsewhere herein. Government pursuant to a solicitation issued prior to December 1, 1995, the Program is provided with "Restricted Rights" as provided for in FAR, 48 CFR 52. 227-14 (JUNE 1987) or DFAR, 48 CFR 252. 227-7013 (OCT 1988), as applicable. EasyData Page 29 Page Reference This PDF document contains electronic bookmarks designed for easy on-screen navigation. If you decide to print this document, please use the page numbers below to find specific topics. [. . . ]