User manual TERRATEC KOMPLEXER

[. . . ] TerraTec Producer KOMPLEXER VST English manual Version 1. 00, from: July 2006 The software described by this document is subject to a License Agreement and may not be copied, reproduced or otherwise transmitted or recorded for any purpose without prior written permission by TerraTec Electronic GmbH. The information in this document is subject to change without notice and shall not be deemed as a warranty by the seller. No warranties, express or implied, are given with regard to the quality, suitability or accuracy of this document. The manufacturer reserves the right to change the contents of this document and/or the associated products at any time without the provision of prior notice to specific persons or organizations. [. . . ] The last 28 sounds are created as init sounds. As the default setting, only layer 1 is enabled. For each sound, the MACRO controllers are associated with the following parameters: MACRO controller Expression Character Warp Effect Attack Decay Sustain Release Parameter Cutoff Filter 1 Resonance Filter 1 LFO 1 Speed FX 2 Effect Amp. Release Because the KOMPLEXER VST represents a more advanced stage of development (optimized oscillators and filters) and many features have been adapted to the current needs of users, not every sound from microQ can be converted on a 1:1 basis. Particularly those sounds that use wavetable oscillators may sometimes sound different due to the different wavetables. However, it is also possible to load in other compatible wavetables. However, the arpeggiator of the microQ also differs slightly from that of the KOMPLEXER VST. Thus imported arpeggiator sounds may also sound different compared to microQ. 12 KOMPLEXER Manual EN MAIN screen On the MAIN screen, advanced users can intervene more deeply in the sound structure. The three oscillators, the mixer and the two filters are located in this screen. For faster editing, the three LFOs and two envelopes are also placed here. For ease of operation on the MAIN screen, you do not have to constantly switch screens in order to configure the basic settings for a new sound. You can also edit the LFOs and ENVs in greater detail on the ENV/LFO screen. OSCILLATOR 1+2 Oscillators 1+2 are identical except for a few details. You can determine the basic pitch using Octave, Coarse and Fine. The six buttons for the waveform are located below. For the waveforms Pulse, WT1 and WT2, you can change the pulse width (Pulse) or wavetable pointer position (WT) by clicking and dragging the waveform display. From the drop-down menu under PWM, select the desired source for pulse width modulation or wavetable. You can also switch off the oscillators using the buttons next to the logo, for example to conserve CPU resources. Wavetables - WT1 and WT2 are the two wavetables that can be selected for oscillators 1+2. A wavetable consists of 33 waveforms that are smoothly superimposed in real time, KOMPLEXER Manual EN 13 while older Waldorf synthesizers and the PPG changed waveforms in hard steps. This you have the ability to smoothly superimpose two waveforms that are next to each other, which provides an even greater variety of sounds. Click the waveform display to manually cycle through the wavetable or modulate it using PWM. Two wavetables with 33 waveforms each are available for each bank. [. . . ] Alt Up - All pressed notes are played in a loop from bottom to top, then from top to bottom. Alt Down - All pressed notes are played in a loop from top to bottom, then from bottom to top. Octave Range - The upper range of the pressed notes is extended by adding the set number of octaves. Pattern - 16 predefined patterns and one user pattern are available. [. . . ]