User manual TERRATEC MYSTIFY440

[. . . ] English Manual Version: 30. 09. 02 CE Declaration We: TerraTec Electronic GmbH, Herrenpfad 38, D-41334 Nettetal, Germany hereby declare that the product: TerraTec Mystify 440 to which this declaration refers is in compliance with the following standards or standardizing documents: 1. EN 55024 The following are the stipulated operating and environmental conditions for said compliance: residential, business and commercial environments and small-company environments. This declaration is based on: Test report(s) of the EMC testing laboratory The information in this document is subject to change without notice and shall not be deemed as a warranty by the seller. No warranties, express or implied, are made with regard to the quality, suitability or accuracy of this document. [. . . ] Please note: Beware of electrostatic discharge. It can cause severe damage to sensitive computer components. When installing the graphics board, be sure to ground yourself by wearing an antistatic wrist strap or touching metal parts of the PC before touching electronic components. TerraTec Mystify 440 (English) 9 Installing the card 1. Switch the computer off (leave the power cable connected, however, to ensure that the computer is grounded) and remove the monitor plug. Don't forget to ground yourself before touching the old or new graphics board. 3. Remove the old graphics board if present. First, remove the screw holding the slot plate of the card to the case. Grasp the card by the edges and carefully pull it out of its slot. Next, carefully insert your TerraTec Mystify 440 into a free AGP slot and gently press it into the slot until completely seated. Replace the screw in the case to retain the graphics board and close the case. Reconnect the monitor cable and switch on your PC and monitor. 10 TerraTec Mystify 440 (English) Installing the TerraTec Mystify graphics board driver software Introduction In this chapter we'll briefly explain how to install the drivers for your TerraTec Mystify graphics board. A setup program can be found on the included driver CD. Here's how: installing the drivers The driver software on your CD includes the following components: · · Windows 9x/ME/2000/XP drivers Microsoft DirectX 8. 1 Driver installation The setup program The installation of the drivers in Windows 9x/ME and Windows 2000/XP is child's play thanks to the user-friendly setup program. Installing the drivers under Windows 9x/ME/2000/XP 1. Install the TerraTec Mystify graphics board on your mainboard (see previous chapter) 2. Boot your Microsoft Windows operating system * 4. Insert the TerraTec CD in your CD-ROM drive. If the CD does not launch automatically, double-click "autorun. exe" of the CD. This will launch the autostarter of the Mystify series. Please note: DirectX 8. 1 or higher must be installed before installing the driver software. To install DirectX 8. 1, click on a Mystify 4xxx button on the welcome screen. Next, click the "DirectX" button, then "DirectX" again. Follow the instructions which will then be displayed. [. . . ] Changes or modifications to this product not authorized by the group responsible for the adherence to the regulations could void the FCC certification and negate your authority to operate the product. This device complies with the specifications in Part 15 of FCC rules. Its operation is subject to the following rules: 1. ) The device must not emit dangerous radiation. 2. ) The device must accept interference, including interference that may lead to faulty operation. 16 TerraTec Mystify 440 (English) Limited warranty TerraTec Electronic GmbH (hereinafter: "TerraTec") guarantees the first buyer (hereinafter: "buyer") the product's freedom from defects in materials and workmanship for a period of 24 months if used as intended, installed in the original system under the conditions specified below. [. . . ]