User manual TERRATEC PHONOPREAMP STUDIO USB INSTALLATION

[. . . ] If you have never used any USB devices on your system before, have your Windows 98 SE CD ready, because the installation might call for it. With the computer running, connect the provided cable into your phono PreAmp Studio USB and then plug it into a USB port on your computer. With Windows 98 SE, the "Add new Hardware Wizard" launches automatically and detects the new hardware. [. . . ] You only have to carry out a couple of steps to begin using your phono PreAmp Studio USB right away. With the computer running, connect the cable provided into your phono PreAmp Studio USB and then plug it into a USB port on your computer. With Windows ME, the "Add new Hardware Wizard" launches automatically and detects the new hardware. Simply confirm by clicking "Next". The operating system will locate the standard USB driver by itself. Various operating system files may have to be installed and, if so, you may be prompted to insert your Windows installation CD into the drive. Insert the CD and continue by clicking "Next". You can run though all remaining steps by clicking "Next" and "Finish". You can verify whether the device was installed correctly in the "Device Manager" (Start\Settings\Control Panel\System ­ Device Manager). The device is listed there twice: once under "Sound, video and game controllers" and again under "Universal Serial Bus Controllers". There is just one more step necessary before you begin recording using your new phono PreAmp Studio USB. Open the "Multimedia Properties" (Start\Settings\Control Panel ­ Multimedia) and select the USB audio device as the preferred recording device. phono PreAmp Studio USB Installation (English) 5 This step is necessary for recording with the phono PreAmp Studio USB. The Sound Rescue software from Algorithmix included with the phono PreAmp Studio USB uses the preferred recording device specified here. If at any time you wish to use your normal sound card for recording, simply undo the change you made in this step. In doing so, there is no need to shut down or reboot the computer. 6 phono PreAmp Studio USB Installation (English) Installation Manual for Windows 2000 The phono PreAmp Studio USB does not need any special drivers to function. All it needs is the standard USB drivers, which are an integrated component of the operating system. You only have to carry out a couple of steps to begin using your phono PreAmp Studio USB right away. With the computer running, connect the cable provided into your phono PreAmp Studio USB and then plug it into a USB port on your computer. The operating system registers the phono PreAmp Studio USB by itself. You can verify whether the device was installed correctly in the "Device Manager" (Start\Settings\Control Panel\System ­ Hardware - Device Manager). [. . . ] The device is listed there twice: once under "Sound, video and game controllers" and again under "Universal Serial Bus Controllers". There is just one more step necessary before you begin recording using your new phono PreAmp Studio USB. Open the "Multimedia Properties" (Start\Settings\Control Panel - Switch to Classic View - Sounds and Audio Devices ­ Audio) and select the USB audio device as the preferred recording device. phono PreAmp Studio USB Installation (English) 9 This step is necessary for recording with the phono PreAmp Studio USB. The Sound Rescue software from Algorithmix included with the phono PreAmp Studio USB uses the preferred recording device specified here. [. . . ]