User manual TERRATEC TERRATV+ VXD

[. . . ] ReceiverSystem TerraTV+ / Radio+ Manual (english) 23. 08. 99 TerraTV+ / TerraTV Radio+ 1 CE Declaration We: TerraTec Electronic GmbH, Herrenpfad 38, D-41334 Nettetal, Germany hereby declare that the product: ReceiverSystem TerraTV Radio+, ReceiverSystem TerraTV Radio+ to which this declaration refers is in compliance with the following standards or standardizing documents: 1. EN 50082-1 The following are the stipulated operating and environmental conditions for said compliance: Residential, business and commercial environments and small-company environments. This declaration is based on: Test report(s) of the EMC testing laboratory TerraTec® ProMedia, SoundSystem Gold, SoundSystem Maestro, SoundSystem Base1, AudioSystem EWS®64, AudioSystem EWS88 MT, XLerate, XLerate Pro, Base2PCI, TerraTec 128iPCI, TerraTV+, TerraTV Radio+, TerraTValue, WaveSystem, MIDI Smart and MIDI Master Pro are trademarks registered by TerraTec® Electronic GmbH Nettetal. In most cases, the designations used in this handbook for software and hardware are also registered trademarks and are thus subject to the relevant regulations. [. . . ] The option Video Standard makes it possible for you to choose different television standards. This only makes sense, for example, if you have an NTSC VCR or camera connected to the TV card. Then you can choose the setting NTSC under the option Video Standard, so that the delivered signals can be processed correctly. Make sure that a change in the setting from PAL B, D, G, H, I only occurs under the conditions mentioned. Otherwise the TV signal reception will be limited. The Menu Point "Video Format" Through the menu point Video Format you can determine the size of the picture to be recorded and the number of bytes that are to be used per pixel. fig. 12: In this window, determine the size and number of bytes used for recording. The setting Image Dimensions Through the point Image Dimensions you can choose from three resolutions for the capturing of frames and recording of video sequences: Resolution Result Single Frame OK OK Result Video Sequence 192 x 144 384 x 288 OK Depending on your system/hard drive capability, it is possible that dropped frames can occur. For more information, please read the topic Attention Trap!­ Recording Parameters of Video Sequences in this online manual. Using this resolution always results in dropped frames. This is because the incoming amounts of data of around 17 MBytes are more than any hard drive currently available can process. 768 x 576 OK 32 TerraTV+ / TerraTV Radio+ The Setting Image Format Through this menu point you can determine how many bytes per pixel are used when capturing a frame or recording a video sequence. The more bytes you set to save a pixel, the greater the data yield and the bigger the resulting file will be!Image Format 32-Bit RGB 24-Bit RGB 15-Bit RGB BTYUV YUV9 YUV12 What it Means for the Recording 4 bytes are saved per pixel 3 bytes are saved per pixel 2 bytes are saved per pixel Low data yield through compression Low data yield through compression Low data yield through compression NOTE: Recordings of video sequences made with the BTYUV, YUV9 and YUV12 image formats can only be played back on systems, on which the TV card's drivers are installed. This is because these image formats work in conjunction with special compression formats which are matched to the television hardware. When you prepare a video sequence for use on your system, you can easily fall back on these special compression formats. If you want to give your video clips to other PC users, however, then you should use a RGB format! The Menu Point "Capture Single Frame" Through this menu point you can capture a single frame of the displayed TV/video picture. The size of the recorded picture is determined by the parameters set under Options\Video Format . After you have captured a frame, you can save it as a bmp file by going under the menu point File/Save As. . . To display the TV/video picture live again after you have captured a frame, simply press the Live Video key in the symbol bar, which is shown here on the left. You can also use the key combination Ctrl+A to capture a frame. TerraTV+ / TerraTV Radio+ 33 The Menu Point "Copy to Clipboard" After you have captured a single frame, you can copy it onto the Windows clipboard by going to the menu point Copy to Clipboard. From there, the frame can be pasted into any number of other applications. Pasting can be done by using the key combination Ctrl-V or the menu point Edit\Paste. The Menu Point "Video Recording Settings" This menu point allows you to choose from numerous settings which will have an effect on the recording of a video sequence. You can find more information on this menu point in the topic Attention! [. . . ] The higher the number of frames per second, the more data. As the screen resolution and the number of frames per second can be set relatively freely, the accruing data yield is determined by these factors. With the TV software's standard settings, one minute uses up about 50 MB of the hard drive. Question 9: Won't the radio software still run after updating to a new driver version?Answer 9: In this case, please download the new radio software version 2. 52 from our home page. [. . . ]