User manual THEBEN ECO-IR 180A@ECO-IR 360A

[. . . ] Important The ECO-IR is designed for use in combination with fluorescent lamps (FL operates with standard ballasts) and energy saving lamps (PL). 1 2 3 4 5 6 7 8 9 Safety Function and performance characteristics Mounting and connecting the device Applications Putting the device into operation Warranty Copyright Troubleshooting Technical data (rear of instruction manual) Danger All work on the 230 V power supply must be performed by authorized trained personnel only. Incorrect handling of the device can lead to serious injury or cause With indirect lighting, ensure that the main part of the light from these lamps is not directed at the detector as this affects the daylight measurement. [. . . ] 5m, larger movements are required and the detection areas of multiple detectors should overlap at their edges. In order to ensure that persons are detected correctly, the detection range must not be impaired by office equipment, partitions, plants etc. Note ECO-IR presence detectors should not be used as alarms. Detection of movements, not seated persons, rooms with clear overview. ) Detection of seated persons with low movement, rooms without a clear overview, difficult activities, large distance from detector (reading rooms, laboratories, workshops, high-precision assembly areas, computer rooms etc. After you have defined the settings, connect the upper part to the power section. Each time the sensor head is attached to the power section or after the power supply is connected, a startup phase (90 sec. Important Avoid using force when assembling the unit. Ensure that the two parts are aligned correctly. The two switching contacts are closed for approx. After the unit has been assembled (startup phase). the lighting system lights up continuously and the ventilation system is in operation. In the subsequent servi ce phase, the ECO-IR responds immediately to changes in brightness in order to test the set brightness switching value (Lux) quickly. The lights can be switched off by "blinding" the sensor with a torch. the service phase is completed automatically after 10 minutes. Repeat the setting procedure if it is necessary to modify one of the three variables. [. . . ] After the service phase, the system response to a change in brightness is delayed to prevent sudden activation / deactivation. Cause tor from fluorescent lamps too high. Switch off devices with instant heat emission (e. [. . . ]