User manual THEBEN LU 102-180

[. . . ] Rotate the coding dials gently with a screwdriver, adjust them to your desires positions (See Fig. Note: System channel (or house channel) and unit channel have each 16 sets coding that provide flexible combination capability a total of 256 (16x16) different combinations. Make sure the arrowheads are adjusted to the proper positions. â· Make sure the transmitter and receiver are set with the same channel i. [. . . ] Avoid Nuisance Triggering Transmitter LU 102/180 HF can be activated by any large animal, light reflective surface, heat source, or a moving object. The following guidelines will help you avoid nuisance triggering. â· Avoid the object moving directly toward the motion detector that brings the less sensitivity of detection. Have the object move across the pattern zone that brings more sensitivity of detection (See Fig. Less sensitive by directly moving toward the motion sensor Do not aim the sensor toward any kind of lighting sources (See Fig. Avoid having the sensor toward the area or the object whose surfaces is highly reflective or is subject to rapid changing in temperature, such as the pool, etc. Installation procedure Note: Before starting to install Transmitter LU 102/180 HF, please test and make sure Transmitter LU 102/180 HF and the combining receiver can work normally in the selected zone. Turn power off before installing Transmitter LU 102/180 HF. Read the Instruction Manual carefully before proceeding. Loosen the screws of the front case with a screwdriver and the screws will not fall down, will stay at front case's screw holes (See Fig. Break the knock-hole of the back case (knock-hole 1 or knockhole 2 as per your requirement) of the junction box. Fix the rubber grommet to the knock-hole and have the power wire through the knock-hole (See Fig. 12 red blue brown white white yellow/green After wires connection, fix the wires with cable clamp (See Fig. Cover the front case and screw it up (See Fig. Fix the metallic bracket of 500W halogen light to the desired position with two screws (See Fig. Fix the body (sensor with halogen light) onto the mounting bracket (See Fig. Usage of lens shielding label In order to reduce detection coverage, you can use lens label, which is supplied with this instruction manual to cover transmitter's lens. 17 shows various detecting patterns while use the lens label in different When environment is applicable for LUX, trigger the transmitter LU 102/180 HF, LED of LU 102/180 HF turns on for about 5 seconds and turns off then. At the same time, the load controlled by LU 102/180 HF turns on and turns off too. the load's light-up time is decided by the time set of the Transmitter LU 102/180 HF. After time set reaches, LU 102/180 HF can be re-triggered and LED may light on for about 5 seconds and light off. Before time set reaches, re-trigger the sensor, the combining receiver is able to receive the signal and time set re-count then, but LED does not light on again. [. . . ] Following is the echoic table between transmitters and receivers of HF Theben series. When Transmitter LU 102/180 HF fails to work normally, check assumptive problems and suggested solutions in following table that will be hopeful to solve your problem. Make sure wirings are correct and has power input. Restore power and check if indicator (LED) turns on. [. . . ]