User manual THEBEN REC 100 HF

[. . . ] do not adjust System Channel to "A" position and Unit Channel to "1" position on all Theben series. Though Theben series provide 256 combinations for channel settings, the best for the user is to use 255 combinations and exclude one combination A1 from your channel setting because A1 is very easy to get interference from other similar product in the market that eventually makes wirefree device abnormal working. [. . . ] Please shut off all power supplies before installation. Fix the bottom case tightly with screws on the selected position (See Fig. There are two options of wire connection as below a. Before wiring, break the reserved knock-holes that allow wires pass through. â· After wiring, make sure all wires are correctly connected. In accordance with your existing wiring layout, choose wires either pass through the inside wall or through the outside wall (See Fig. Set channel, if its is necessary, then cover the front case and fasten it with four screws (See Fig. Through inside wall Through outside wall Switch opened (is controlled by transmitter) Switch closed (is not controlled by transmitter) Transmitter and Receiver interwork by means of sending ON or OFF signal from a Transmitter to its combining Receiver and correspondingly a Receiver receives the signal from the combining Transmitter and reacts to the signal received. Following is the echoic table between transmitters and receivers of Theben series. The LED of Receiver REC 100 HF turns on and the control unit of Receiver REC 100 HF starts to work upon receiving ON signal from any combining transmitter. The LED of Receiver REC 100 HF turns off and the control unit of Receiver REC 100 HF stop working upon receiving OFF signal from any combining transmitter. The working time of the control unit of Receiver REC 100 HF depends on the time setting of transmitter (LU 102-180 HF only). [. . . ] Push OFF button of the combining transmitter at least 2 seconds. Push OFF button of Transmitter too short. [. . . ]