User manual THERMA DH CAMINO SE1

[. . . ] This may be done by making sure the air inlet into the room passes through nonclosing openings such as air recycling wall boxes, doors, windows or with other technical measures. Please, keep to the provisions of official directives regarding the question of fume discharge. No food must be cooked flambe underneath the hood. [. . . ] -- To install the filter, fit it in the seat at the front and fasten it at the back with the two hooks B (Fig. Close the shutter P before using this version of the hood (Fig. 4) -- Position the template in the correct position and make two 8mm diameter holes and two 12mm diameter holes. -- Fit the two 8mm diameter plugs in the top holes. -- Fasten the two hooks C in the bottom holes. -- Hang the hood on the hooks and level it with the screws D. -- Secure it in place with the two 5x45 mm screws and 5-20 mm diameter washers in the top holes. The screws and washers are standard equipment. MAINTENANCE Before performing any maintenance operation, disconnect the hood from the electricity. Grease filter This serves to hold the grease particles in suspension. To remove the filter, push it towards the back of the hood and pull it downwards (Fig. To clean, wash it in hot water and biodegradable detergent. Clean it at least once a month. INSTALLATION When installed, the hood must be not less Installing the duct for venting to outside (exhaust version) (Fig. 5-6) -- Fasten the top support E to the wall close to the ceiling on the perpendicular of the 10 11 Carbon filter This filter dissolves cooking odours. It should be changed every 4 months in normal use. Ask the technical assistance service or manufacturing company for a new one. To remove the carbon filter, push the pushbuttons B inwards and pull the filter downwards (Fig. 2). I DESCRIZIONE DELLA CAPPA 1) Tasto velocità motore 2) Tasto luce 3) Spia di funzionamento 4) Griglia d'aspirazione 5) Illuminazione piano di lavoro INSTALLAZIONE (Fig. [. . . ] Chiudere le serrandine P prima di utilizzare la cappa in questa versione (Fig. 10). Fissaggio della cappa al muro (Fig. 4) -- Posizionare la dima nella giusta posizione ed eseguire 2 fori Ø 8 mm e 2 fori Ø 12 mm. [. . . ]