User manual THERMADOR 19-10-271I

[. . . ] OWNER: Please retain these instructions for the future reference. Safety Warning: Turn off power circuit at the service entrance and lock out panel, before wiring this unit. IMPORTANT SAFETY INSTRUCTIONS WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Installation Work and Electrical Wiring Must Be Done By Qualified Person(s) In Accordance With All Applicable Codes & Standards, Including FireRated Construction. The combustion airflow needed for safe operation of fuel-burning equipment may be affected by this unit's operation. [. . . ] This Models To control housing is deVM410 390 Fig. 1 signed for use with any VR600 525 Fig. VR1000 Fig. 1 3-1/2" ¦ ¦ ¦ Minimum 3" Length of 3-1/4" x 10" 1-1/2" dia. ¦ ¦ 1-3/4" ¦ ¦ 13" · · CAUTION: Vent to outside of building. COLD WEATHER installations should have an additional backdraft damper installed to minimize backward cold air flow, and a nonmetallic thermal break to minimize conduction of outside temperatures, as part of the duct work. The damper should be on the cold air side of the thermal break. The break should be as close as possible to where the ducting enters the heated portion of the house. ¦ ¦ 3/8" ¦ 1-3/16" 3-1/4" x 10" Backdraft damper (supplied with VM410) DUCTING FOR VM410 Cut duct opening through the cabinet shelves to required sizes, use 3-1/4" x 10" rectangular duct, or use transition #1255-7 and a 7" round duct. Finish with Roof Jack #12556 or Wall Cap #1255-1. Make sure the dampers at the hood and roof jack are free to open. See Figure 1. NOTE: Discharge collar is shipped with the ventilator. Recommended Installation Height -- Countertop to top of each VCH unit: Bottom of cabinet -- Over normal countertop cooktop or range, Thermador's Griddle'n Grill, etc. , 30" to 40", over indoor barbecue -- 40" to 48". Recommended for use only over conventional domestic gas or electric appliances. Not recommended for use over solid fuel fired barbecues. CLEANING INSTRUCTIONS Fig. 2 1-1/2" Dia. ¦ 1-3/4" ¦ ¦ ¦ ¦ For maximum efficiency, clean filter and hood frequently. Do not allow grease to accumulate on hood or ventilator surface. 10-7/8" ¦ ¦ 12-1/4" ¦ ¦ ¦ 1-1/4" CAUTION: Do not use scouring or abrasives cleaners as they could permanently mar the finish. 1. To Clean the Filter -- Open housing and remove filter. Filter may be washed in your dishwasher or washed in warm soapy water, rinse, drain and dry before installing. To Clean Motor and Blade Unit (VM410 only) -- Remove filter and disconnect plug. Loosen wing nut, swing hanger rod out of the way or scroll bracket and rotate blower until the mounting flanges come free. Wipe entire unit clean with a damp cloth. Do not use a dripping wet cloth as water may enter the motor and cause damage. To prevent distortion of wheels, always handle the blower by the handle -- not by the ends. [. . . ] The VCH unit is 11-15/ 16" wide at top and 9-3/8" high from top to bottom. ¦ OPERATING INSTRUCTIONS This Thermador Ventilating Hood has been developed as a combination unit to use with a cooktop or range. The ventilator should be turned on 5 minutes before cooking in order to draw the currents of air upward through the hood. That way when heat, smoke, moisture, grease and cooking odors arise, they will be carried upward and forced outside, thereby minimizing their drift into other rooms. Drafts across the cooking surface from an open window, door, etc. , may cause the escape of heat, smoke, moisture, grease and cooking odors from the hood. [. . . ]