User manual THERMADOR 19-12-182H

[. . . ] Do Not Use To frigeration and Air Conditioning EnExhaust Hazardous Or Explosive Materials And Vapors. READ AND SAVE THESE INSTRUCTIONS Recommended for use only over conventional domestic gas and electric ranges, and use with an approved Thermador Hood. Fig. 1 TOP VIEW Down Slope of Roof or Wall I. Remove and discard shipping bracket (attached to motor mounts and inlet collar). Check to see if blower wheel turns freely. [. . . ] WIRING TO A WALL MOUNT 4 POSITION VENTILATOR SPEED CONTROL SWITCH: 1. Use Thermador 4 position ventilator speed control model CTR3Q (purchased separately). Power supply required for these ventilators is 15 amps. wires (black, white and green) from the power supply at the electrical circuit panel to the wall box. Run electrical conduit per local code to conduit outlet in bottom of ventilator as shown in Fig. Other end of conduit will connect to wall box with 4 position switch. wires in conduit between Ventilator J-box and 4 position switch. Use color coded wire corresponding to colors shown in Figure 8. Use wire nuts to connect wires as shown in Figure 8. 2 21 21 21 21 21 ¦21 21 21 21 21 21 21 21 21 21 21 21 21 21 Outside Wall ¦ ¦ ¦ IV. FOR WIRING TO A WALL MOUNT INFINITE VENTILATOR SPEED CONTROL SWITCH MODEL VTR600R ONLY: 1. Use Thermador infinite speed control switch model #SSC1C (Purchase separately). Power supply required for these ventilators is 15 amps. connected per local codes. NOTE: There should be two (2) excess wires (blue and red) from the motor. These wires are not needed for wiring to this infinite ventilator speed control switch. These wires should be individually capped with wire nuts and pushed back inside the wiring compartment on the remote ventilator VTR600R. Fig. wires (black, white and green) from the power supply at the electrical circuit panel to the wall box. Run electrical conduit per local code to conduit outlet in the bottom of ventilator as shown in Figure 5. Connect other end of conduit to wall box with speed control switch as shown in Figure 9. Run three (3) #14 AWG wires in conduit between VTR600R and the infinite ventilator speed control switch. Use color coded wire corresponding to wire colors shown in Figure 9. 9 wiring diagram. WARNING: Disconnect power before installing switch. Before turning power on, be sure that all controls are in the OFF position. 1/2" Thin Wall Conduit Ventilator Wall Switch Model CTR3Q or SSC1C (VTR600R Only) (Not Provided) Fig. [. . . ] Locate the Cooking Area for minimum cross drafts, away from doors and windows, etc. , when possible. For best performance duct runs should be as short and as straight as possible. Where turns are necessary, keep turning radius as large and as smooth as possible. Thermador reserves the right to change specifications or design without notice. Some models are certified for use in Canada. [. . . ]