User manual THERMADOR 35-05-274A

[. . . ] b) Always turn hood ON when cooking at high heat or when cooking flaming foods. Grease should not be allowed to accumulate on fan or filter. Always use cookware appropriate for the size of the surface element. Page 2 WARNING - TO REDUCE THE RISK OF INJURY TO PERSONS, IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: a) SMOTHER FLAMES with a close-fitting lid, cookie sheet, or other metal tray, then turn off the burner. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. [. . . ] ON button and motor speed selection button 1, 2, 3, 1, . . . . If the motor is off while the timer is pressed the motor will run at speed 3 for 20 minutes then stop. If the motor is running when the timer key is pressed the motor will continue to run for 10 minutes. Pressing the timer or speed button while the Timer LED is on will disable the timed mode. Dim Light ON/OFF button (only for model HTNI). Circuit Self-test The control allows the user to perform a self-test to check the correct function of the hood. The self test is activated by pressing the A and B keys simultaneously for 3 seconds. OPERATING INSTRUCTIONS - HOOD The blower should be turned on for 10 minutes before cooking in order to establish air currents through the hood. This will improve the capture and removal of heat, smoke, moisture, grease and cooking odors. Use the low speeds for normal use and the higher speeds for strong odors or fumes. Drafts across the range or cooktop will reduce the effectiveness of the hood. Such drafts should be prevented when possible. Fig. 1 Grease Filter Saturation LED The speed 2 LED in Figure 1 in is marked with an F. This LED will flash to remind you when the grease filter needs to be cleaned after 40 hours use. Follow the instructions for cleaning filters in thisFollow the instructions for cleaning filters in this booklet. Once the grease filters have been cleaned, reset the display by pressing button A for 3 seconds until you hear the signal (beep). Page 4 CLEANING INSTRUCTIONS FILTERS The metal grease filters are made of anodized aluminum and are long lasting. To Remove The Metal Grease Filter/s Turn blower and lights off. For Models HNI, HTNI Push each handle in the direction of the arrows as shown in Fig. To Replace The Metal Grease Filter/s Reverse procedure. Be sure lights are cool before cleaning the hood. To Clean Filter/s It is recommended that the filters be washed at least once a month; they can be washed by hand or in the dishwasher. Drain water through holes and along filter edges and allow to dry thoroughly before replacing it. To Clean Hood Surface For general care, wipe the outside of the stainless steel, white, black or glass hood with sudsy water or household cleaners such as Fantastic® or Formula 409®, rinse well and dry with clean soft cloth to avoid water marks. Wipe and dry brushed stainless steel in the same direction as the grain. [. . . ] A. , the District of Columbia and Canada. Should the appliance be sold by the original purchaser during the warranty period, the new owner continues to be protected until the expiration date of the original purchaser's warranty period. Products for use in Canada must be purchased through the Canadian distribution channel to ensure regulatory compliance and warranty coverage. This warranty gives you specific legal rights. [. . . ]