Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual THERMADOR 5020009162A. We hope that this THERMADOR 5020009162A user guide will be useful to you.
Lastmanuals help download the user guide THERMADOR 5020009162A.
Detailed instructions for use are in the User's Guide.
[. . . ] Please retain these instructions for future reference. Disconnect power at the breaker before installing.
Table of Contents
Step 1: Step 2: Step 3: Step 4: Step 5: Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Cabinet Preparation . . . . . . . . . . . . . . . . . . . . [. . . ] The electrical requirements for a separate circuit serving only this microwave oven are: 120V, 60Hz, 20Amps
Step 4: Installing the Trim Kit
Position the two vertical trim brackets using the template as shown on Figure 3. Mark the center line of the cutout using the template. The template is used to locate the positions of the left and right trim brackets with respect to the cut out. The trims are secured with three (3) screws each and the template is discarded thereafter.
Figure 3
Trim Brackets Centerline Notch to mark the center line of the cutout
¨
Screws #8 x
1/4"
¨
¨.
Template
Page 5
Step 5: Installing The Microwave Oven
Note: The four (4) ducts have a plastic covering that must be removed prior to installing them onto the microwave. Position Side Duct on left side of oven. Fasten with outer case screw removed in Step 2. Position Upper Exaust Duct on top (hinge side) of oven and fasten it together with Side Duct by using two (2) screws #8 x1/4". Remove and retain Outer Case Screw at rear of the oven (right side). Install the Grommet and the electrical cord of the microwave in the receiving hole provided in the Rear Intake Duct and position this duct on rear of the oven (right side). Position Top Intake Duct on upper right side of oven and fasten it together with rear intake duct by using four (4) screws #8 x1/4". Secure all duct flanges to oven with tape provided. Press tape to secure properly.
4.
WARNING
These ducts have sharp edges. Position the oven's four (4) cone-shaped legs on the base pan's four (4) large holes. Fasten with five (5) screws #8 x 1/4". Remove and retain Outer Case Screw at left side of the oven. 6.
2.
7.
8.
Upper Exhaust Duct
Outer Case Screw Top Intake Duct Screw #8 x 1/4" Rear Intake Duct
Side Duct
.
Screw 8 x 1/4" Microwave Oven
¨
.
Grommet
Figure 4
Base Pan
Page 6
¨
Outer Case Screw
.
Step 5: Installing The Microwave Oven (continued)
9. Remove the left side vertical trim bracket (three screws) (MT27B only).
10. Slide the assembled microwave oven part way into the prepared cabinet cutout. [. . . ] Thermador is not responsible for products which are transported from the United States for use in Canada. Check with your local Canadian distributor or dealer. Thermador, 5551 McFadden Avenue, Huntington Beach, CA 92649. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE THERMADOR 5020009162A
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual THERMADOR 5020009162A will begin.
