User manual THERMADOR 5060002189C

[. . . ] 4 Electrical Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 IMPORTANT: INSTALLER: OWNER: Save these instructions for Local Electrical Inspector's use. Please leave these Installation Instructions with this unit for the owner. Please retain these instructions for future reference. READ AND SAVE THESE INSTRUCTIONS OVERALL DIMENSIONS A B JUNCTION BOX LOCATION D See Illustration A, Page 2. [. . . ] CLASSIFIED MINERAL AND FIBER BOARDS SURFACE BURNING CHARACTERISTICS Followed by the flame spread and smoke ratings. , these designations are shown as "FHC (Flame Spread)/ (Smoke Developed)". Materials with "O" flame spread ratings are flame retardant. Local codes may allow other flame spread ratings. The minimum horizontal clearance from the sides and back edge of the cooktop to the adjacent vertical combustible walls is 0 Inches. A foam tape is provided to seal the cooktop edges to the countertop, F, (see Page 4). Turn cooktop upside down and apply tape approximately 1/16" from the glass edges to the underside of the cooktop glass. Use tape around the entire glass perimeter cut off excess where tape ends butt. SECURE COOKTOP TO COUNTERTOP G The cooktop should be secured to the countertop using the hold-down brackets provided. Prior to inserting cooktop into cutout, turn cooktop upside down and attach brackets to the burner box using the washers and screws. Insert clamping screw into the bracket and secure cooktop to countertop. Use a wood block to protect fragile countertop materials. PAGE 3 Installation Instructions Models: CET304, CET365, CEP304, CEP365, CEP456 PAGE 4 Installation Instructions Models: CET304, CET365, CEP304, CEP365, CEP456 SOLID SURFACE COUNTERTOPS H ELECTRICAL CONNECTION 1. Attach flexible conduit to the junction box. Connect the cooktop lead wires to the junction box supply wires in proper phase: Always consult the countertop manufacturer for specific instructions. granite and marble) or SOLID SURFACE MATERIALS, such as SurellTM and Corian ® , require special cutout preparation and installation procedures. Follow the guidelines in preparing the cutout dimensions. Round the cutout corners according to instructions from the countertop manufacturer. Apply heat reflective tape (such as Scotch Aluminum Foil Tape #425 or #427) around the cutout so that it folds over the top and side surfaces. Be sure the tape extends beyond the outermost flange of the cooktop. All corners should also be covered with tape. Attach brackets to the burner box using washers and screws provided. Use a wooden block underneath the countertop before tightening the bracket screws. Center cooktop in the cutout to insure adequate clearance between the burner box and countertop edge. (A light pencil mark along the center of front edge and side edge of cooktop and counter will aid positioning of the cooktop in the center. ) 5. Trim excess aluminum tape along the frame edges. [. . . ] For the most detailed information, refer to installation instructions accompanying product or write Thermador indicating the model number. We reserve the right to change specifications or design without notice. Some models are certified for use in Canada. Thermador is not responsible for products which are transported from the United States for use in Canada. [. . . ]