User manual THERMADOR PHE INSTALL

[. . . ] When the service disconnecting means cannot be locked, attach a tag to the service panel to indicate power has been switched off for maintenance. Installation Work and Electrical Wiring Must Be Done By Qualified Person(s) In Accordance With All Applicable Codes & Standards, Including Fire-rated Construction. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturers guideline and safety standards such as those published by the National Fire Protection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. FILE # E21958 READ AND SAVE THESE INSTRUCTIONS LI06EC Ed. [. . . ] Both vertical and horizontal discharge are possible with either mounting method. Discharge Direction: Discharge Direction: The PHE hood is shipped ready for vertical discharge. To change to horizontal discharge simply move the two plates marked A in Figure 1 to the top of the hood. Each plate is held in place by two sheetmetal screws. Transition: Assembly of the T ransition: The transition supplied with the PHE hood mounts to the top or rear of the hood depending on the discharge direction. Align mounting holes at base of transition with mounting holes on 1/2" flange located at the top or rear of the hood depending on direction of discharge. Fasten transition to hood using 6 (4 mm x 9. 5 mm) screws (included with hood). Duct tape connection between transition and hood. Remove tape holding damper closed. Figure 1 Page 4 Wall Mount Installation The desired installation height of the PHE is the user's preference. Figure 2 shows a typical installation of the hood with two duct covers. Thermador offers 6" and/or 12" duct covers to fill the space between the hood and ceiling. The installation height shown in Figure 2 is 24". One 6" and one 12" duct cover have been used in this installation. Hood Installation Height After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the desired hood installation height plus 15. 5". This line is the mounting location of the wooden bracket shipped with the hood. Draw a vertical line along this centerline up to the horizontal line drawn in step 1. The PHE is mounted to the wall using a wooden bracket shipped with the hood. Remove the bracket from the hood by removing two shipping screws. Mark the centerline of the bracket. Figure 2 covers as appropriate to accommodate ceiling height and desired hood height. The duct cover structure is supported by the hood. Page 5 4. Find studs behind the drywall by tapping the wall or using a stud finder. Locate one stud on either side of the cooktop centerline to use for mounting the wooden bracket as shown in Figure 3. 7. Use 2-4 (6mm x 80 mm) screws to attach the bracket to the wall as shown in Figure 3. [. . . ] Hang hood from screws and tighten securely. Install two wall anchors as described in step 15 on the previous page. Page 10 Installing an Integral Blower: The PHE hood can be installed with Thermador's VTN1000Q blower. In the 30" PHE model remove the two spacers A shown in Figure 12. Each spacer is held in place by three screws. Wiring the PHE with an Integral motor: arning: Turn off Warning: Tur n off electricity at the service before panel before wiring the unit. [. . . ]