User manual THERMADOR ISLAND HOODS

[. . . ] 8 Retain this manual for future reference. Note: The Thermador Hood referred to throughout this manual is manufactured by BSH Home Appliances Corporation. PAGE 2 IMPORTANT SAFETY INSTRUCTIONS WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1 . Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer (800/735-4328). Before servicing or cleaning the unit, switch power off at service panel and lock ser vice panel. [. . . ] When the control sensor reaches 140ºF (60º C), a reset will occur. During reset, the control will revert back to the operational state prior to the high temperature condition. High Temperature Fault Condition - The circuit is equipped with an alarm indicating that the heat sensor protection is not working, due to a damaged sensor. In the case of this extreme condition, the three speed indicator LEDs will start blinking. All the controls will be operational except for the speed indicators. FAN SPEED Pressing button once, from an off state, turns the ventilator on low. Each successive press of the button increases the fan speed until high where the fan cycles back to the low speed. · The LEDs above this button indicate the current fan speed. When the fan is on, the corresponding LED is illuminated. 1 ­ Low 2 ­ Medium 3 ­ High DELAY SHUT OFF · Press to turn fan on high for 10 minutes. If the ventilator is off when the delay button is pressed, the ventilator will turn on to the high speed setting for 10 minutes. At the end of the cycle the ventilator will turn off. If the ventilator is on when the delay button is pressed, the ventilator runs for 10 minutes at the current speed then turns off. · During a timed period, the LED above the Delay Shut Off button is illuminated. · To interrupt a timed period, press Fan Speed or Off button. CLEAN FILTER REMINDER After 40 hours of operation, the clean filter reminder LED above this button will illuminate indicating that the filters need to be cleaned. When this indicator illuminates, clean the filters as instructed on page 6. After cleaning, press this button for 3 seconds to reset the 40-hour period and turn the LED off. LIGHT On/Dim/Off This button controls the halogen lighting. A third press turns the lights off. HEAT LAMP (for Wall Hoods Only) The buttons marked "L" and "R" independently control the left and right infrared heating lamps, turning the lights on or off. PAGE 5 CARE AND CLEANING To Clean Hood Surface · For general care, wipe the outside of the stainless steel with sudsy water or household cleaners such as Fantastic ® or Formula 409 ®, rinse well and dry with a clean soft cloth to avoid water marks. Wipe and dry stainless steel in the same direction as the grain. Avoid using too much pressure, which may mar the surface. Do not use abrasive products such as steel wool. To remove finger prints and give added shine, use spray cleaners such as Stainless Steel Magic® and Shimmer ® . Do not allow any cleaning compounds to remain in contact with stainless steel for extended periods. 1 2 3 ® · · · OFF FAN SPEED DELAY A AY SHUT OFF FILTER L LTER LIGHT Figure 3 NOTE: DO NOT USE COOKTOP WHILE HOOD IS DISASSEMBLED. [. . . ] Reset circuit breakers or replace home fuses. Damage caused from accident, alteration, misuse, abuse, improper installation or installation not in accordance with local electrical codes or plumbing codes, or improper storage of the appliance. Travel fees and associated charges incurred when the product is installed in a location with limited or restricted access. (i. e. , airplane flights, ferry charges, isolated geographic regions). [. . . ]