User manual THETFORD AQUA MAGIC GALAXY PARTS

[. . . ] Do not flush non-dissolving articles such as feminine hygiene products, paper towels, or moist towelettes, as this will damage the macerator and will void your warranty. Do not let the pump run dry, as this will damage the macerator. Flush all debris from the holding tanks prior to installation. To avoid pump failure, if you are using an accessory water hose on the end of the nozzle, make sure that the inner diameter of the hose is 3/4 in. [. . . ] Most Sani-Con systems have a built in power control switch. However, some systems allow the user it install a remote power control switch. If installing a remote power switch make sure it is easily accessible. All systems rely on gravity to move the liquid waste to the pump; therefore, make sure that the pump inlet is mounted below the RV dump valve. Flush all debris from the holding tanks. position the pump housing or "box" on the compartment floor or wall. When positioning the pump make sure; it is lower than the dump valve the inlet hose reaches the dump valve the power switch is accessible Do not overtighten the hose clamp when adjusting the hose length, as this may damage the hose. Fasten the box to the mounting surface using the self-tapping screws (provided). Note: Two gaskets are included with Due to different RV connections, one or both gaskets may be needed to ensure proper sealing. Flush all debris from the holding tanks. Make sure that the installed unit will not interfere with the operation of the gray and black water RV dump valve handles. point the nozzle upward and remove the nozzle cap. Insert the nozzle into the sewer connection and give it a half-turn to lock the nozzle into the connection. Important: Before opening the black water dump valve, open the gray water dump valve and run the pump for a few seconds to confirm that the system is operating correctly. If there is a problem with the connection or if the system is not functioning correctly, you might need to remove the pump and motor from the sewer pipe, which is much cleaner to do when running gray water. Shut the gray water dump valve and turn the pump switch to the Off position once you have determined that there are no problems. The pump will run at a louder pitch when the tank is empty. Turn the pump switch to the Off position when the tank is empty. The pump will run at a louder pitch when the tank is empty. Turn the pump switch to the Off position when the tank is empty. Do not run the pump dry, Pump running dry, do NOT turn the pump on to use the gray water bypass, as the gray water bypass relies on gravity. Make sure that the black and gray water RV dump valves are closed. [. . . ] Insert a screwdriver into the screwdriver slot located on the bottom of the motor (some models have an access port cover that will need to be removed to access the screwdriver slot). Waste discharge stops or decreases dramatically. Turn the pump switch to the Off position, and check for foreign matter lodged in the inlet hose or pump. Failure to clear a clog could cause damage to the pump, which will void the warranty. [. . . ]